Re: Nvidia NIC and SUSE 9.0

From: Thomas Tootle (chipslayer_at_hotmail.com)
Date: 03/12/04 

Date: Fri, 12 Mar 2004 07:30:16 -0500

Synchrodude wrote:

> Thomas Tootle wrote:
>
>> Greetings,
>> I can't seem to get they onboard NIC with the Nvidia Nforce2 chipset
>> working with SUSE 9.0. I loaded the driver from Nvidia and used Yast to
>> configure it but the boot log shows eth0 as failed. When I go back into
>> Yast it has the correct IP address, subnet mask, gateway, DNS servers and
>> nvnet module. But it won't ping or connect to the net. Been googling but
>> unsuccessful. I'm running a dual boot system and all works fine in WinXP
>> so it isn't hardware but operator failure. Pointers gratefully accepted.
>>
>> Thanks,
>> T
>
> What Mobo and do you have the latest BIOS update for it? If not you might
> need to flash your BIOS and then try and load the Nforce drivers. Also you
> did load the Nforce drivers and not the video drivers right? :) just to
> make sure.
> http://www.nvidia.com/object/linux_nforce_1.0-0261
>
Thanks Dude,
I'm using Nvidia_nforce-1.0-0261.suse90.i586.rpm. Any other suggestion?
Tom

Relevant Pages

  • Re: Installing XP Pro sp2 - setup cannot copy file nvatabus.sys
    ... So normally there is no reason to hit F6 or to integrate the nForce SATA drivers as TEXTMODE drivers. ... Have a look into your mainboard manual, if you have to enable SATA and RAID within your BIOS, even when you have not built a RAID array. ...
    (microsoft.public.windowsxp.general)
  • Re: How do you install mobo drivers?
    ... So I downloaded them and installed them but after I rebooted I noticed that the "Safely Remove Hardware" icon was in the sys tray. ... I ended up using System Restore to get things back to normal but I would like to know how to install these drivers properly so I can keep my PC up to date. ... Samsung 500GB HD501LJ Spinpoint Sata II ... If they don't appear there with your older nForce drivers, THAT would be the mystery that needs explaining. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Ethernet appears to be connected but actually isnt
    ... Installed latest nVidia nForce 2 drivers which are required for ethernet ... A single network connection appears ... I tried both with and without Windows Firewall enabled. ... Your nVidia nForce 2 has its own firewall ... ...
    (microsoft.public.windowsxp.network_web)
  • Re: Nvidia NIC and SUSE 9.0
    ... > I can't seem to get they onboard NIC with the Nvidia Nforce2 chipset ... need to flash your BIOS and then try and load the Nforce drivers. ...
    (alt.os.linux.suse)
  • Re: Replacements for 2SA1302/2SC3281
    ... operation you do not connect any load. ... Higher power amplifiers with a low impedance main feedback network ... might load the drivers too hard and cause you to waste silicon. ... you should be able to get a 120 V P-P waveform on the scope. ...
    (sci.electronics.repair)