Re: xine and kaffeine jumping

From: Vlad (miles123_at_gmx.de)
Date: 05/23/04 

Date: 23 May 2004 09:11:59 -0700

Carl,

is DMA switched on for your DVD device ?

If you are running in PIO mode, then the results from playing
a DVD are terrible.

So check the DMA setting for your DVD drive.
If DMA is Off, then turn DMA on.

 Regards,
Vlad!

Relevant Pages

  • DMA settings
    ... CD-RW drive I added a LG GSA-4129B DVD writer (to replace the original DVD ... I was having some problems recently writing to DVD+RW disks for my backups. ... Secondary IDE Channel Advanced Settings tab had the transfer mode set to DMA. ... but the current transfer mode is always showing PIO mode. ...
    (microsoft.public.windowsxp.setup_deployment)
  • DMA Settings
    ... CD-RW drive I added a LG GSA-4129B DVD writer (to replace the original DVD ... I was having some problems recently writing to DVD+RW disks for my backups. ... Secondary IDE Channel Advanced Settings tab had the transfer mode set to DMA. ... but the current transfer mode is always showing PIO mode. ...
    (microsoft.public.windowsxp.hardware)
  • Re: [SLE] CD/DVD Combo drive problem (Was: DVD playing problem)
    ... > This is typical behaviour when not useing dma. ... Set this in YAST not via ... But when a DVD is in the drive, ... When I go into Xine to try to play the DVD, ...
    (SuSE)
  • Re: Takes forever to burn a DVD - final results
    ... changes to force DMA because I'm not using XP. ... occur at high speed once the encoding finally ends. ... The actual DVD burn time was only 8 minutes, which is about 7.5x, close to the 8x rated speed of the Maxell DVD-R blank. ...
    (alt.video.dvd)
  • Brennproblem mit ISO
    ... Wenn ich eine ISO-Datei brenne waoraus danach eine DVD soll entstehen, ... DMA: Off ... Recorder: HP DVD Writer 300n, ... Sense Key: 0x05 ...
    (de.comp.hardware.laufwerke.brenner)