Re: Sound Blaster Live! LS EMU10K1 driver

From: baskitcaise (baskitcaise_at_hotmail.com)
Date: 10/31/04

  • Next message: Ulrich Hartge: "Spell Check in 9.2 German" 
    Date: Sun, 31 Oct 2004 07:14:00 +0000

    Johnny Kapikki adjusted his/her tin foil beanie and asbestos underwear
    to write:

     
    > I did try disabling the AC97 chip in the BIOS, like GreyGeek said he
    > did. It didn't make my sound card work, but it did make KAmix crash
    > before it was able to load as usual. I went back into the BIOS, and
    > re-enabled AC97 until I can figure out something different to try. I'm
    > ready to try almost anything.

    Hi Johnny,

    Just a thought:-

    In Yast, Do you have the SB as the first card?

    I have my SB/Live 5.1 ( old version ) set as card 0, and my onboard as
    card 1.

    I use my AC97 for my headset and mic, and the SB as system sounds etc..

    I had the onboard disabled and then cleared all from Yast and started
    detection again and configured the SB first, made sure that all sounds
    came from the SB and then rebooted and enabled my onboard and
    configured that.

    I use a child panel off kicker and added 2 separate "sound mixer"
    applets which gives me complete control over both cards with all the
    sliders, the reason I use these mixers is to get over the initial
    problems Suse 9.1 had that is shown in this SDB article:-

    http://portal.suse.com/sdb/en/2004/05/thallma_91_sndsilence.html

    HTH 

    -- 
Mark
Illegitimi Non Carborundum!
Twixt hill and high water, N.Wales, UK
onfxvgpnvfr-ng-tzk-qbg-pb-hx
  • Next message: Ulrich Hartge: "Spell Check in 9.2 German"

    Relevant Pages

    • Re: What do you think, will connecting a ST-225 work (part 2)
      ... the card seems to be configurable for DMA3 and PIO. ... First thing to do is to low-level format the drive with the ... there are no system BIOS settings needed to ... does disabling both IDE in BIOS PERIPHERAL SETTINGS make ...
      (uk.comp.homebuilt)
    • Re: Home to Pro Upgrade halts and now PC inaccessible
      ... disabling NIC in the bios didn't help so I pulled every card out of the ... I rebotted and re-enable NIC in the bios and I'm back on the road again! ... "Mark L. Ferguson" wrote: ...
      (microsoft.public.windowsxp.help_and_support)
    • Re: Turning off camera also kills card reader on EeePC 900
      ... You should check that the SD card stays disabled when you ... The settings are persistent (so changing a camera value that is 0 to 1 ... will show the camera as being enabled if you go to the BIOS). ... option for disabling the cardreader. ...
      (Linux-Kernel)
    • Re: Lost Sound
      ... BIOS, only reference is AC97. ... disabled AC97 in BIOS, installed a new sound card/drivers. ... > tried disabling the onboard in the BIOS and flashed the BIOS to the latest ...
      (microsoft.public.windowsxp.hardware)
    • Re: How to Disable Onboard Card
      ... You did remember to plug the monitor into the new card didn't you?? ... download" so I could update the BIOS, ... computer already had a 32 MB S3 Savage, how do I disable the onboard? ... tried disabling it in the Device Manager, ...
      (microsoft.public.windowsxp.hardware)
    Loading