suse 9.1 with linksys pci eth, outgoing bytes counter always zero
From: Ugor Stanisky (me6_at_privacy.net)
Date: 11/30/04
- Next message: chriske911: "Re: little problems 1st install"
- Previous message: Derk: ""could not start the cookie server process""
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Tue, 30 Nov 2004 17:24:36 +0100
hello there,
i have some suse 9.1 (x86) box with some
0000:02:01.0 Ethernet controller: Linksys Network Everywhere Fast
Ethernet 10/100 model NC100 (rev 11)
Subsystem: Unknown device 1734:100c
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (16000ns min, 32000ns max), cache line size 08
Interrupt: pin A routed to IRQ 9
Region 0: I/O ports at 3000
Region 1: Memory at d0100000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=100mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
configured as eth0
Linux box01 2.6.5-7.111-default #1 Wed Oct 13 15:45:13 UTC 2004 i686
i686 i386 GNU/Linux
IF-MIB::ifDescr.2 = STRING: eth0
IF-MIB::ifInOctets.2 = Counter32: 159529
IF-MIB::ifOutOctets.2 = Counter32: 0
the ifOutOctets.2 always stays at zero. is this some known bug with this
card? which one is the driver for this card actually? is there any way i
could fix this bug by installing some different suse kernel or apply any
patches or anything the like?
i have setup some simple mrtg for the load on that eth device, but it
only displays the incoming bandwidth, the outgoing curve stays at zero.
thanks already for any help.
- Next message: chriske911: "Re: little problems 1st install"
- Previous message: Derk: ""could not start the cookie server process""
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
