How can I set a network card to active....



Hi!

I have SuSe 10 on my laptop which has a built in network card which is
not configured. I have also a Netgeat MA521 PCMCIA wireless card which
i have finally got 'working'.

I say 'working' because i have got the link light on the card to light
up, meaning (i think) that the card and Linux sees the existence of my
wireless router (Netgear MR814) but i can't actually get out on the
internet and the router does not see the PC Card as attached.

Upon further investigation i HTTP server set up and noticed my PC Card
is not listed under interfaces so that led me to assume it is not the
active connection, maybe my onboard card is? If i plug a cable in
there all works well!

So, my question is, how can i set my Netgear card to active? I plan to
use the computer in a different room to my router so a wired
connection is not an option.

Thanks for any tips in advance!

Engelkott



.

Relevant Pages

  • Re: netgear wireless
    ... > wireless PCI card all for $40. ... the pci card uses ... Abut the Netgear and similary priced D-Link router. ...
    (Fedora)
  • WGU624 + MA401 = little or no range at all.
    ... conjunction with a Netgear MA401 card in a Dell Latitude L400 laptop. ... I was away most of the summer I never got to hooking up the new router ...
    (alt.internet.wireless)
  • Re: Canā?Tt make wireless work
    ... Definitely don't waste money on phone calls when a Netgear is so cheap!! ... >> I bought a wireless router, and a wireless card for a desktop ... Hooked up the router to another computer with an ethernet ... Router hooked up to the ethernet card and the DSL router. ...
    (microsoft.public.windowsxp.general)
  • Re: [SLE] help netgear router config
    ... > I am trying to get Netgear card to work and have been ... > Now the link lights are flashing and I can ping the ... > relation to the router. ...
    (SuSE)
  • Re: slink boot error in OpenServer 3
    ... After a couple of days with no replies I did replace the card ... a Netgear FA310TX NIC. ... I'm using the same driver for the Netgear as before. ... hardware boot screen shows the correct address, IRQ, and MAC address ...
    (comp.unix.sco.misc)