Re: Mercury kobian TV Tuner
- From: Rory Remenak <bozo_spamhater@xxxxxxxxxxxxxxxxxxx>
- Date: Thu, 30 Mar 2006 13:29:11 -0800
On Thu, 30 Mar 2006 19:35:45 +0000, Craig wrote:
Hi all,
Ive been trying to enable a Mercury TV tuner on suse 10 with no success so
far. Ive located the chipset and a lspci -v gives
02:01.0 Multimedia controller: Philips Semiconductors SAA7130 Video
Broadcast De
coder (rev 01)
Subsystem: Unknown device 18d0:2100
Flags: bus master, medium devsel, latency 64, IRQ 3 Memory at
fdcfe000 (32-bit, non-prefetchable) [size=1K] Capabilities: [40]
Power Management version 1
Ive tried using Xawtv & kdetv both dont produce either sound or picture as
I belive drivers/tuner are not installed. Through googling ive found that
card comes under LifeView FlyVIDEO3000.
However when selecting this through YAST it indicates there is no
tuner available. Not sure if its relevant but when trying out few other
cards & tuners and then scanning channels through yast I get the error The
Kernel module for TV support could not be loaded
Could anyone guide me in the right direction to get this working?
TIA
Googling shows this card is a video4linux card. Make sure the video4linux
software is installed (use Yast) and check out the video4linux wiki at:
<http://www.linuxtv.org/v4lwiki/index.php/Main_Page>
----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----
.
- References:
- Mercury kobian TV Tuner
- From: Craig
- Mercury kobian TV Tuner
- Prev by Date: Re: Can't get WiFi to work
- Next by Date: Re: Can't get WiFi to work
- Previous by thread: Mercury kobian TV Tuner
- Next by thread: install 9.2
- Index(es):
Relevant Pages
|
