Re: LVM with YaST

Chris Cox wrote:
It won't automatically expand the size of any partitions contained
within a volume group.

So how do I add extra volume to LVM?

After you have added the extra partition/disk to the volume group,
you can extend the logical volume and then you have to resize
the underlying filesytem.

When I go to the LVM in YaST, I see the physical volume as 151.6GB abd
the logical volume as the same size, after I told to add it. Before that
it was 121 and 37

Not sure about doing all of that via YaST, but easily done
from the command line... something like the following...

pvceate /dev/sdb7

Command not found and I also do not have a /dev/sdb7
I would realy be interested in doing it with YaST, because I believe
that is where it should be handled correctly as well.

houghi
--
They say pesticides have been linked to low sperm counts.
In my opinion if you have bugs down there that are so bad
you need to use a pesticide, you're not gonna get laid anyway.
.

Relevant Pages

  • Re: Confusion over LVM
    ... It's odd as command 'ls' is working fine, and when I run 'yum install ... Subject: Confusion over LVM ... filesystem) with current version... ...
    (Fedora)
  • Re: How to fix two disks with the same Volume Group?
    ... you'll have to prefix the lvm commands with lvm, ... Is this under repair on the install cd? ... where you'll find a command prompt. ... Surely not if you've just changed the name using the repair disk? ...
    (Fedora)
  • Re: How to fix two disks with the same Volume Group?
    ... you'll have to prefix the lvm commands with lvm, ... Is this under repair on the install cd? ... where you'll find a command prompt. ... Surely not if you've just changed the name using the repair disk? ...
    (Fedora)
  • Re: Veritas file manager
    ... > the commandline as easily as LVM. ... > reference somewhere on the Veritas website. ... VxVm gives an admin the ... Now that I know how to use it, I even work with Omniback via command line. ...
    (comp.sys.hp.hpux)
  • Re: LVM2 recover/resotre with a drive failure?
    ... figured that it should have LVM support, ... Through a find command, I found ... SATA card I was using or the new drive. ... to another SATA port on my SATA controller card and will try it later ...
    (comp.os.linux.setup)