Re: opensuse JAD distro (report)

On Wed, 31 Jan 2007 11:09:02 +0000, darklight wrote:
just change the system frequency to 1000hz


?? I am not sure what you are talking about-- how would I do that? What
frequency are you talking about--cpu, bus, latency (I tried the BIOS
latency settings all the way from the lowest to the highest and still get
that fricken Rosegarden error about too low a latency timing for MID).

.

Relevant Pages

  • Re: PC wont Start, even in safemode
    ... Take out one stick of DDRAM. ... If it boots with one, ... Manually enter the correct latency for sticks into BIOS. ...
    (microsoft.public.windowsxp.general)
  • Re: [patch] voluntary-preempt-2.6.8.1-P2
    ... >> This would confirm the hypothesis of a buggy BIOS, ... I don't think the latency tracer is involved. ... phenomenon as the regular latency spikes I reported earlier. ... preempt threshold violations was 1ms). ...
    (Linux-Kernel)
  • Re: 2.6.20 PCI Cannot allocate resource region 2
    ... Either with success or failure. ... I expect BIOS to have complained before launching grub/lilo. ... Maybe BIOS is clobbering BIST when writing latency timer or cacheline size ... PCI is by nature a 32-bit wide config space and "byte enables" ...
    (Linux-Kernel)
  • Re: A8N-SLI Premium and TWINX1024-3200C2 latency timings
    ... CAS# Latency: 3.0 clocks ... The Corsair web site says the TWINX1024-3200C2 latency timings are ... Row Cycle Time tRC Bios Default ... Write to Read delay Bios Default ...
    (alt.comp.periphs.mainboard.asus)
  • Re: A8N-SLI Premium and TWINX1024-3200C2 latency timings
    ... CAS# Latency: 3.0 clocks ... The Corsair web site says the TWINX1024-3200C2 latency timings are ... Row Cycle Time tRC Bios Default ... Write to Read delay Bios Default ...
    (alt.comp.periphs.mainboard.asus)