make a usbkey bootable
- From: heavytull <heavytull@xxxxxxxxxxx>
- Date: Sun, 29 Apr 2007 00:05:33 +0200
I tried to make a USK key ext2 partition bootable with extlinux but
that didn't work.
actually this is to put slax on it.
I proceeded as follows:
made the partition with fdisk and wrote the fs with mkfs
the device is /dev/sda and the partition is /dev/sda1
I copied all files from cd to the mounted sda1
#cd /mnt/sda1
#mv boot/*.gz ./
#mv boot/splash* ./
#mv boot/vmlinuz ./
#mv syslinux.cfg extlinux.conf
i then vimed extlinux.conf and removed '/boot' of the path to access
initrd.gz at both lines in whch it appears.
#extlinux -i ./
cat mbr.bin >/dev/sda
this is derived from the method i found on the slax forum in which
they install on a FAT32 partition and which I tried for curiosity and
it didn't work.
and the rest of my method is derived from the extlinux.doc found in
the syslinux package.
Since i did exactly what was written in the extlinux.doc it should
work although i don't understand how it can work:
the file mbr.bin has to be written in the few first bytes of the hard
drive, but i don't understand how the system will reach the partition
on which to boot since i could have choosen sda4 or sda3 or sda2 as
well as sda1. I think the mbr has to link to the boot partition,
unless i get a menu at boot.
--
heavytull
.
- Follow-Ups:
- Re: make a usbkey bootable
- From: heavytull
- Re: make a usbkey bootable
- Prev by Date: Bad picture taking session
- Next by Date: Re: make a usbkey bootable
- Previous by thread: Bad picture taking session
- Next by thread: Re: make a usbkey bootable
- Index(es):
Relevant Pages
|
