Re: Wireless Woes
- From: Darren Green <darrenfgreen@xxxxxxxxxxxxx>
- Date: Tue, 30 Oct 2007 13:21:14 +0000
Dr. Deb wrote:
Darren Green wrote:
Hi.
As a newbie I have been trying to setup my Atheros Wireless card following
one or two of the Gentoo Wiki's.
I emerged a number of items, wireless tools etc but to no avail. When I
run 'lspci' I receive the following:
00:03.0 Ethernet controller: Realtek Semiconductor Co Ltd
RTL-8139/8139C/813C+ (rev 10) - My 10/100 Ethernet Card
00:04.0 Ethernet controller: Atheros Communications, Inc AR5212 802.11abg
NIC (rev 01) - My Wireless Card
An ifconfig shows:
eth0 - MY LAN Ethernet card present in use
l0 - My loopback address
If I do a iwconfig I get:
lo no wireless extensions
eth0 no wireless extensions
sit0 no wireless extensions
I e-mailed one of the Linux forums and was asked if I had run 'modprobe
ath-pci' which I hadn't. When I do I get the following result:
Warning: Error inserting ath_ha1
(/lib/modules/2.6.22-gentoo-r8/net/ath_ha1.ko): invalid module format
Warning : Error inserting wlan
(/lib/modules/2.6.22-gentoo-r8/net/wlan.ko): invalid module format
: Error inserting ath_pci (/lib/modules/2.6.22-gentoo-r8/net/ath_pci.ko) :
invalid module format
Can anyone point me in the right direction please so that I can resolve
this error.
Regards
Darren
Darren, I am not a Gentoo user so I need to ask a question first. Does
Gentoo use repositories to store additional programs on the net? If it
does, download "madwifi" and then try to install you wireless.
It really will get easier, when I first started installing mine I wondered
if I had suddenly taken "stupid" pills. The users group is a good place
for information, but what really helped me was "someone with skin on". In
this case my daughter who lives about 900 miles away. There are a
few "niceities" that they will point out as you go through that the rest
of us would overlook.
Deb
Deb,
Thanks for those words of encouragement.
I am keen to learn Linux, been in Cisco networking for the last 5 x years and wanted to learn an OS other than MSoft.
I re-read the Gentoo WIKI document again this morning and re-traced my steps. I did download the madwifi tar file, did a make and then a make install. No errors when compiling but when I ran the modprobe again I got the same result.
I'll keep googling, I am sure that I will get there eventually :-)
Regards
Darren
.
- Follow-Ups:
- Re: Wireless Woes
- From: Dr. Deb
- Re: Wireless Woes
- Prev by Date: Re: opensuse 10.3 or ubuntu / kubuntu 7.10
- Next by Date: How to mount a Freecom USB hard drive?
- Previous by thread: Where to post non-html code?
- Next by thread: Re: Wireless Woes
- Index(es):
Relevant Pages
|
|
