Re: NIC question: Via-Rhine (D-Link VT86C100A) full duplex?

On Fri, 22 Feb 2008 20:15:41 +0000, Mike wrote:

Been digging around trying to figure out how to make my D-Link VT86C100A
NICs run at full duplex.

In sure I've seen somebody else's output that included "full_duplex" in
there somewhere.

Clues anyone?

Whether your NIC can run at full duplex or not is at least partially
dependent on the device it's plugged into. If it's set to auto-negotiate
duplex and comes up half duplex then it's probably a good idea to leave it
that way.

--
I told you this was going to happen.

.

Relevant Pages

  • RE: Network Transfer Slow....
    ... the NICs of the computers that were playing up (set to 100Mbps/full duplex). ... Our Network switch was set to autonegotiate (necessary in case somebody ...
    (microsoft.public.windowsxp.network_web)
  • Re: NIC Link Speed of auto negotiation
    ... command line, half/full duplex? ... It's up to the NIC driver to provide that, ... Those settings are on both NICs on my server, ... Is there a way of show the link speed of a auto negotiated connection? ...
    (microsoft.public.windowsxp.general)
  • Re: Forcing Duplex settings
    ... Your solution is to "change the duplex settings", but how do you know there isn't an easier or better solution, and how do you know you've got to the bottom of the problem by this change? ... We have ssen similar problems with some Intel nics, ... There is a wmi value to read out the connection speed but that is read ... everything to do with the network was messed up. ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: NIC Link Speed of auto negotiation
    ... I have never been sure when to use Full or Half Duplex with my desktop machines or server, and have been suspicious about using Auto as the best policy. ... It's up to the NIC driver to provide that, ... Those settings are on both NICs on my server, and three machines here, with separate NICs or onboard. ...
    (microsoft.public.windowsxp.general)
  • Re: Gnat Box Light
    ... > Anyone have any experience with gnat box light? ... > appears to work..It dials out when I ping a external ip. ... Since you've ruled out the cable, check to make sure both nics are ... ie auto or manual 100mb/s full duplex. ...
    (comp.security.firewalls)