Re: getting hw infos in linux
On Sat, 20 Sep 2008 21:12:02 +0000, heavytull wrote:
I would like to know whether my computer supports sata I or sata II.
does anyone know how to get this information? I guess i have to check in
/proc
I checked in /proc/bus, but found nothing.
Do you want to know if your computer supports sata, or if you OS supports
sata? The linux kernel can support sata. You need to figure out what
motherboard you have, and see if it supports sata.
sf
.
Relevant Pages
- Re: Is SATA compatible with IDE Hard drives
... I've yet to encounter a single motherboard that did ... not permit a boot from a properly-connected PATA hard drive. ... I don't own any SATA capable PCs, ... > complaints about simultaneous IDE and SATA hard drives, ...
(microsoft.public.windowsxp.hardware) - Re: problem with my new sata hard disk
... yesterday i brougt new sata hard disk along with all ide to sata ... My guess would be the converter is not the right type. ... The motherboard has an ICH4 Southbridge and two ribbon cable IDE ... hard drives larger than 137GB. ...
(alt.comp.hardware.pc-homebuilt) - Re: "How I built a 2.8TB RAID storage array"... 7 months later
... The problem is SATA HDs ... Do you know where I can obtain SATA HDs for about 200 $? ... If you want to go much cheaper, you could get a non-server motherboard ... Linux software RAID 5 and JFS. ...
(alt.comp.hardware.pc-homebuilt) - Re: problem with my new sata hard disk
... yesterday i brougt new sata hard disk along with all ide to sata ... like an IDE drive. ... The motherboard has an ICH4 Southbridge and two ribbon cable IDE ...
(alt.comp.hardware.pc-homebuilt) - Re: Disk Boot Failure, Insert System Disk and Press Enter
... Interface from hard disk to motherboard is using sata2 cable ... The SATA controller is integrated in the Intel ... connector. ... You may have to make a fresh install anyway. ...
(microsoft.public.windowsxp.hardware) |
|
