Cannot Boot!!!!

From: satya kumar (i_satya_at_yahoo.com)
Date: 07/16/03 

Date: 16 Jul 2003 02:32:39 -0700

Hi All,
We are using a Arcom Box which uses RHlinux(2.4.18). It has a onboard
Flash and a compac flash. Our kernel and the filesystem resides in the
onboard flash and the compaq flash houses all the requied software
which is started after the boot up.
The probelem we are facing is suddenly the system hangs and if the
system is rebooted it stops with a message....
init: no more process left in this runlevel.
Is this something to do with the Flash filesystem getting corrupted.
The same footprint of Linux kernel and rootfilesystem is working fine
on some systems while some are giving this typical problem.
Anybody has any idea as to what can be the reason.Plese help me out I
am stuck.
Thanks for the help.
Regards,
Satya

Relevant Pages

  • Re: platform builder 4.2 debugger cannot connect to target
    ... I have a 10 M Extension Ethernet card. ... Enable Full Kernel Mode --- yes ... I captured the serial port output during the download and boot up. ... Downloading operating system image for flash target. ...
    (microsoft.public.windowsce.platbuilder)
  • VFS: Unable to mount root fs on unknown-block(1,0)
    ... my linux kernel is 2.6.10 and the artesyn board has the following ... FLASH: 64 MB ... ramdisk support is built into the kernel ... PCI Autoconfig: Found Bus 0, Device 2, Function 0 ...
    (comp.arch.embedded)
  • HELP! VFS: Unable to mount root fs on unknown-block(1,0)
    ... the board is diskless, a compressed kernel image ... FLASH: 64 MB ... a compressed ramdisk ... PCI Autoconfig: Found Bus 0, Device 2, Function 0 ...
    (comp.os.linux.embedded)
  • Re: v2.6.21.5-rt19 (sched_getaffinity?)
    ... on my desktop but on my laptop it makes Firefox and Tomboy to crash. ... I managed to completely hang firefox with flash 9 installed ... Firefox with flash 9 does not work good, there are a lot bugs reported ... The problem is the rt kernel AFAICT, this goes beyond Flash 9, way ...
    (Linux-Kernel)
  • rootfs as JFFS2 on AT91SAM9260
    ... I don't know which options I should use to configure the linux kernel. ... I use U-Boot to flash my roofs.arm.jffs2 at 0xD0528000 and I launch ... # Loadable module support ... # RAM/ROM/Flash chip drivers ...
    (comp.os.linux.embedded)