ifAddrAdd

From: Gabi (gabi_at_tdsoft.com)
Date: 07/14/04 

Date: 13 Jul 2004 23:34:26 -0700

Hi,
I'm looking for a way to add IP address to IP interface, something
like the ifAddrAdd in VxWorks.
tanks
Gabi

Relevant Pages

  • VxWorks 6.6 - Ethernet interface driver support
    ... I am currently working on the porting of a board system from VxWorks ... So far I have been successful only with the electrical DSS PMC ... Ethernet interface cards, deploying the "Intel PRO/1000 VxBus Enhanced ... Network Driver" in conjunction with the "Generic PHY driver", ...
    (comp.os.vxworks)
  • Custom Protocol with MUX_PROTO_PROMISC & ping issues
    ... I am running Vxworks 6.1 on MPC platform. ... However when I run a smartbits / ping test against the ethernet ... to ping to its interface from an outside host very quickly. ... During send I use netTupleGet to allocate memory for my ethernet ...
    (comp.os.vxworks)
  • Re: Bind succeeded but not receiving mulitcast packets
    ... I have a mulitcast server program. ... I have added the interface to the ... programming the multicast filter correctly. ... VxWorks, ...
    (comp.os.vxworks)
  • Re: Two Ethernet Port Configuration
    ... I have a Single Board Computer running Vxworks 5.5.1 which has two ... ethernet controllers type. ... The BSD networking stack (upon which the VxWorks 5.5.1 network stack ... has to go through that one particular interface. ...
    (comp.os.vxworks)
  • Re: Problem with Dual Ethernet Interface on Target
    ... PC1 needs to have a route entry for PC2 network via vxworks1 interface. ... PC2 needs to have a route entry for PC1 network via vxworks 2 ... SubnetMask - 0xffffff00 ... packets received; 0 packets sent ...
    (comp.os.vxworks)