D875PBZ - RAID 0 Config / Network Driver
From: Paul Hendricksen (paulh_at_linuxmail.org)
Date: 07/30/03
- Next message: Dr. A.R. Peters: "digital camera Ricoh Caplio G3 & Linux?"
- Previous message: fishbowl_at_conservatory.com: "New Linksys card is BROADCOM?!?"
- Next in thread: Derek Clarkson: "Re: D875PBZ - RAID 0 Config / Network Driver"
- Reply: Derek Clarkson: "Re: D875PBZ - RAID 0 Config / Network Driver"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 29 Jul 2003 19:01:11 -0700
I just recently started to install Gentoo 1.4_rc2 on my new machine.
The machine consists of an Intel D875PBZ Motherboard straddled with
the new Intel 3.20Gz processor. Equipped with two Seagate 160 ATA hard
drives, configured for RAID 0.
My dellema is this: I am trying to setup partitions and cannot. Due to
this new machine being my only computer with RAID I have NO clue where
to start. If you have any ideas on how to get the RAID 0 setup feel
free to comment.
-[ToXiC]
- Next message: Dr. A.R. Peters: "digital camera Ricoh Caplio G3 & Linux?"
- Previous message: fishbowl_at_conservatory.com: "New Linksys card is BROADCOM?!?"
- Next in thread: Derek Clarkson: "Re: D875PBZ - RAID 0 Config / Network Driver"
- Reply: Derek Clarkson: "Re: D875PBZ - RAID 0 Config / Network Driver"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
