Re: adding SCSI disks to IDE linux system
From: Jack E. Wilkinson (jw2_at_drbear.com)
Date: 10/13/03
- Next message: Måns Rullgård: "Re: adding SCSI disks to IDE linux system"
- Previous message: w_tom: "Re: PII vs PIII"
- In reply to: Steve Wolfe: "Re: adding SCSI disks to IDE linux system"
- Next in thread: Måns Rullgård: "Re: adding SCSI disks to IDE linux system"
- Reply: Måns Rullgård: "Re: adding SCSI disks to IDE linux system"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sun, 12 Oct 2003 18:25:01 -0500
On Sun, 12 Oct 2003 15:31:18 -0600, "Steve Wolfe" <unt@codon.com>
wrote:
>
> Looking at the output of dmesg will probably help quite a bit. : )
thanks... just did and here's what i find.
PCI: Enabling device 00:11.0 (0016 -> 0017)
PCI: Found IRQ 11 for device 00:11.0
PCI: Sharing IRQ 11 with 00:0d.0
scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.8
<Adaptec 2940A Ultra SCSI adapter>
aic7860: Ultra Single Channel A, SCSI Id=7, 3/253 SCBs
Vendor: HP Model: 9.10GB C 80-P94N Rev: P94N
Type: Direct-Access ANSI SCSI revision: 02
scsi1:A:1:0: Tagged Queuing enabled. Depth 253
Attached scsi disk sda at scsi1, channel 0, id 1, lun 0
(scsi1:A:1): 10.000MB/s transfers (10.000MHz, offset 15)
SCSI device sda: 17773524 512-byte hdwr sectors (9100 MB)
sda: sda1
scsi : 1 host left.
doing...
[root@olympia root]# fdisk /dev/sda1
Unable to open /dev/sda1
[root@olympia root]# ls -l /dev/sda
brw-rw---- 1 root disk 8, 0 Oct 12 13:41 /dev/sda
jack
- Next message: Måns Rullgård: "Re: adding SCSI disks to IDE linux system"
- Previous message: w_tom: "Re: PII vs PIII"
- In reply to: Steve Wolfe: "Re: adding SCSI disks to IDE linux system"
- Next in thread: Måns Rullgård: "Re: adding SCSI disks to IDE linux system"
- Reply: Måns Rullgård: "Re: adding SCSI disks to IDE linux system"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|