Re: Best Fanless 3D Video Card

From: Linux (linux_at_nospam.invalid)
Date: 01/04/04 

Date: Sun, 04 Jan 2004 00:14:10 -0400

begin on Sun, 04 Jan 2004 01:04:49 +0000, Vigil wrote:

> On Sat, 03 Jan 2004 16:33:19 -0400, Linux wrote:
>
>> Just cut the 12V (yellow) line and paste it onto the 5V (red) line. The
>> fan runs real quiet then.
>
> I'd assume it'd run (dangerously) slow as well...

Define dangerous. If you want to do this without cutting, there are small
devices with a knob that can set the voltage to a level you feel is not
dangerous, whatever that means.

Relevant Pages

  • Re: Set Up
    ... do you know the difference between a welding torch and a cutting ... smaller holes around the center hole for the preheating flame. ... You then open the fuel knob a very slight bit and light it using ...
    (sci.engr.joining.welding)
  • Re: Replacement knob for hassock fan?
    ... I have an older Sears hassock fan that I have been saving, ... The problem is that the control knob ... The stem has two flat sides and a groove through the ... and so far the only replacement knob I've been able to find at a ...
    (alt.home.repair)
  • Replacement knob for hassock fan?
    ... I have an older Sears hassock fan that I have been saving, ... The problem is that the control knob ... The stem has two flat sides and a groove through the ... and so far the only replacement knob I've been able to find at a ...
    (alt.home.repair)
  • Re: Are Your Retention Knobs Too Tight?
    ... The Knob Problem ... The retention knob is an unmistakably critical component of the ... to the toolholder not seating securely in the machine. ... the cutting tool are not hard to imagine. ...
    (alt.machines.cnc)
  • Re: Are Your Retention Knobs Too Tight?
    ... The Knob Problem ... to the toolholder not seating securely in the machine. ... the cutting tool are not hard to imagine. ...
    (alt.machines.cnc)