Re: Agere Mini-PCI wireless card
Next message: Aidan Whitehall: "Re: PCI graphics card recommendations sought"
Date: Sun, 29 Aug 2004 10:26:47 GMT
General Schvantzkoph wrote:
> Have you tried Ndiswrapper and the XP driver?
Yes, and that didn't work either! And thats using the same driver that works
fine under XP! Ndiswrapper reported "no hardware found" !
????!!
Looking into the .inf file, the pci id list doesn't seem to contain the pci ids
of the actual device (as reported by lspci)! XP seems able to ignore this
somehow (?) but Linux is more fussy! (=correct!)
--
Pete
christy@NOattglobalSPAM.net
(make the obvious amendments to reply!)
Next message: Aidan Whitehall: "Re: PCI graphics card recommendations sought"
Relevant Pages
- Re: [SLE] Help with ndiswrapper?
... > I have downloaded ndiswrapper and the M$ drivers. ... The INSTALL file is your best bet bet but if that fails here's a little ... find your windows driver for your ... you should see wlan0 with a bunch of settings for your nic. ...
(SuSE) - Re: Where can I find this firmware file?
... with "yum install ndiswrapper". ... The ndiswrapper driver is NOT just for the fscking Broadcom ... kmod-ntfs has jack to do with this thread. ... I've been less than happy with the built-in bcm43xx drivers, ...
(Fedora) - Re: Howto configure Wireless Card in FC5
... If the card is plugged in, and there is a native driver ... If there's no native driver, then the next step is up to you. ... I've gone the ndiswrapper route for cards that don't have native drivers ... You obtain the ndiswrapper source and install the wireless-tools package ...
(Fedora) - F9: Installing Ndiswrapper for AWLL6070 (rt2870)
... Ndiswrapper method. ... and so far it *appears* that the drivers were installed and the wlan0 alias ... rt2870: driver installed ... Jul 16 08:23:16 bronze kernel: usb 1-1: reset high speed USB device using ehci_hcd and address 2 ...
(Fedora) - Re: [SLE] Help with ndiswrapper?
... > I have downloaded ndiswrapper and the M$ drivers. ... Remove the current driver with modprobe -r ndiswrapper, ... use your konqi to open and read the install file in that folder, ... you should see wlan0 with a bunch of settings for your nic. ...
(SuSE) |
|
