Error Rate hdd using SMART

From: Jochen Demmer (thinkskateboards_at_gmx.de)
Date: 02/28/05 

Date: Mon, 28 Feb 2005 01:36:58 +0100

Good Evening.

There are errors detected in webmin for my IDE-Harddisks.
First hdd "102 Errors detected" text is red coloured.
Second hdd 198 Errors (red)
Third 3 Errors (also red)

Any Hints?
I already checked all three disks with fsck for errors in the file-system
strucutre as in bad blocks.
The Error log (smartctl) shown lower seems less more critical than the error
rate of about 200.
The Disk with 3 Errors is even 2 years older ... ???
Is there a reason to worry?

<snip>
 Offline data collection status Offline data collection activity was
completed without error.
Auto Offline Data Collection: Disabled.
Self-test execution status The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline data collection 3840 seconds.
Offline data collection capabilities SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
No Selective Self-test supported.
SMART capabilities Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability Error logging supported.
No General Purpose Logging support.
Short self-test routine recommended polling time 1 minutes.
Extended self-test routine recommended polling time 64 minutes.
Raw Read Error Rate 2261 Start Stop Count 1533
Reallocated Sector Ct 2 Seek Error Rate 0
Seek Time Performance 14243
Power On Half Minutes 4503h+22m
Power Cycle Count 445
Temperature Celsius x10 34.5
Current Pending Sector 0
Offline Uncorrectable 0
Multi Zone Error Rate 0
Soft Read Error Rate 29
</snip>

Relevant Pages