Re: Could not recognize the LCD monitor
From: ray (ray_at_zianet.com)
Date: 03/12/05
- Next message: John-Paul Stewart: "Re: need IBM R40e NIC driver for RH9(BCM5700)"
- Previous message: Lenard: "Re: systems stopped booting linux CDROMs"
- In reply to: Hualin: "Re: Could not recognize the LCD monitor"
- Next in thread: Hualin: "Re: Could not recognize the LCD monitor"
- Reply: Hualin: "Re: Could not recognize the LCD monitor"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sat, 12 Mar 2005 08:51:43 -0700
On Fri, 11 Mar 2005 22:11:23 -0500, Hualin wrote:
> Thanks ray. You are right. After lower the refresh rate. I can switch to the
> LCD monitor
> after entering Windows.
> .
> Now, the only problem is that the LCD monitor still can not display BIOS
> information during
> boot. Which is quite inconvenient if I want to install OS.
>
Now that is curious. I would expect the display to revert to a 'lowest
common denominator' (lcd - but that's not really a pun) of 640x480 at 60
hz at bios display - is there a chance your monitor cannot do 640x480?
- Next message: John-Paul Stewart: "Re: need IBM R40e NIC driver for RH9(BCM5700)"
- Previous message: Lenard: "Re: systems stopped booting linux CDROMs"
- In reply to: Hualin: "Re: Could not recognize the LCD monitor"
- Next in thread: Hualin: "Re: Could not recognize the LCD monitor"
- Reply: Hualin: "Re: Could not recognize the LCD monitor"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
