Help with restoring data from failed RAID-0 array

semovrs_at_concord.edu
Date: 05/22/05


Date: 22 May 2005 13:58:28 -0700

Hello, everyone!
My Abit KG7-RAID motherboard one day refused to start my computer. All
I see is flashing lights of my two CD-ROMs when I power the PC up. I
hear no beeps to indicate problems with my graphics card or any other
component.
I have set up RAID-0 with two IDE hard drives. Since the RAID
functionality is integrated in the motherboard I don't know how I can
restore my data from the two hard drives if I figure out that the
motherboard is a dead beat.
Do you know how I can restore this data? I run Linux on my machine and
the RAID-0 array is formatted for ReiserFS. I have not done backup for
almost one year now. I know it was a mistake but any ideas as to how I
can possibly restore any of the data on these two drives would be
greatly appreciated!
Thank you very much for any advice!
Roumen.



Relevant Pages

  • Re: Help with restoring data from failed RAID-0 array
    ... > My Abit KG7-RAID motherboard one day refused to start my computer. ... > I have set up RAID-0 with two IDE hard drives. ... > Do you know how I can restore this data? ... Disk break, it is not a question if, only when, RAID0 doubles the ...
    (comp.os.linux.hardware)
  • Re: PC Wont start
    ... +12V and GND power the fan. ... chip on the motherboard counts the pulses. ... small capacity hard drives, that is a lot better than losing all of ... The simplest test consists of motherboard, power switch (to connect ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: XP Data recovery
    ... You could, in theory, do a repair install with an XP CD full-retail version, ... using the old hard drive and any modern motherboard. ... the older ATA/IDE hard drives, in which case the drivers would not be ... (This, like it or not, is a well known feature of Microsofts licensing ...
    (microsoft.public.windowsxp.general)
  • Re: XP Data recovery
    ... floppy for the SATA controller on the motherboard and then do the F6 ... to have SATA emulate the older ATA/IDE hard drives, ... (This, like it or not, is a well known feature of Microsofts licensing ... Its fairly trivial to recover ordinary files by putting the disc in a USB ...
    (microsoft.public.windowsxp.general)
  • Re: firing up a SATA hard drive
    ... The only reason I'm asking here is because the, wtf do you call it, CI connector that makes sure if you open the side panel without you knowing its a safety device against rip-offs. ... is to get the motherboard and hardware to respond. ... Not to waste time with the Chassis Intrusion cable from the tower. ... What point is there in hooking up hard drives or optical ...
    (microsoft.public.windowsxp.hardware)