Re: boot hangs in POST after connecting SATA HDD

On 28 Dec 2005 11:17:13 -0800, hugovanwoerkomqt@xxxxxxxxx
<hugovanwoerkomqt@xxxxxxxxx> wrote:
> Hi,
>
> I have an EPoX 8VTAI mobo. Has 2 ATA IDE on it already in IDE0 + IDE1.
>
> I bought a SATA WD800JD HDD. I power it up and connect it to the SATA1
> port on the mobo.
>
> I change Integrated Periferals->VIA OnChip IDE->SATA mode=IDE in the
> BIOS Setop.
>
> I reboot and the boot never gets past POST. Just hangs there.
>
> Any suggestions as to what to try next?
>
Disconnect the new drive and see if it can boot. Maybe the drive is
defective.


--
So this is what it feels like to be potato salad
.

Relevant Pages

  • [OT] EP-8VTAI hangs on boot with SATA HDD
    ... I put the SATA WD800JD disk in and connect the cable to either the SATA1 or SATA2 connector on the mobo and boot never gets past the first screen and hangs there after detecting the IDE drives. ...
    (Debian-User)
  • 6.0 panics on boot
    ... panic, Fatal trap 12, page fault at the NVidea driver in the boot. ... pci0: <ACPI PCI bus> on pcib0 ... fdc0: port ...
    (freebsd-questions)
  • RE: Problem with foppy drive
    ... I think I see your problem in the boot log. ... <ACPI PCI bus> on pcib0 ... <Parallel port bus> on ppc0 ... on ppbus0 ...
    (freebsd-questions)
  • fatal trap / spin lock - src from 7/16/04
    ... Console: serial port ... Boot FreeBSD with ACPI enabled ³ ... 0xcc000-0xcc7ff,0xc0000-0xc8fff on isa0 ... page fault while in kernel mode ...
    (freebsd-current)
  • nforce2 usb is broken on -stable
    ... the 2.0 boards lock up on boot during the uhub0 bus ... While I can boot without the devices and attach them later, ... cause the box to reset. ... ohci_root_ctrl_transfer: writing reset to port ...
    (freebsd-stable)