Re: Two ethernet ports in a single hardware

kssandeep@xxxxxxxxx wrote:
I needed some information on what are the prerequisites for having
two
ethernet ports on a single hardware.

You need an expansion bus to plug in the cards, if there aren't multiple
ports on board already.

Assume I have a hardware with a switch on board. This is a two
port switch. So i am assuming that the switch will have in-built
functionality of switching the packets between the two ports. Apart
from this, we would also need some IP routing/Forwarding to be done at
the IP Layer to route packet between the two ports.

In that case you can't use the built in switch, you need two independent
Ethernet ports in your system.

--
Markku Kolkka
markku.kolkka@xxxxxx

.

Relevant Pages

  • Re: probably an easy routing question, so please help
    ... plugged into the same gigabit switch as Server B in Block 2 and they ... from a 10Mb link to the router and the computers are both hooked into ... router with gig ports, you will potentially have limits for any ...
    (comp.dcom.sys.cisco)
  • Re: Configuring Cisco IPS High Bandwidth Using EtherChannel Load Balancing
    ... "If the paired interfaces are connected to the same switch, ... VLANs for the two ports. ... IPS is able to track traffic per-VLAN, ... VLAN Pair mode uses one interface only and this is the only supported ...
    (Focus-IDS)
  • Re: probably an easy routing question, so please help
    ... plugged into the same gigabit switch as Server B in Block 2 and they ... from a 10Mb link to the router and the computers are both hooked into ... router with gig ports, you will potentially have limits for any ...
    (comp.dcom.sys.cisco)
  • Re: running out of IP Address! help!
    ... I believe it could handle 4096 VLANs + router interfaces. ... a layer-3 switch is the way to go. ... having subnets won't prevent broadcasts. ... will only hit ports that are members of that VLAN, ...
    (microsoft.public.win2000.networking)
  • Re: Auto-sensing for IPS devices
    ... Auto-Negotiation is essential in larger networks. ... about 1000's of switch ports and PC's connecting/disconnecting ... the ports at whatever they need to be. ... > you MUST set BOTH speed and duplex settings and you MUST set BOTH ...
    (Focus-IDS)