help? Install SiS900 PCI fast ethernet Adapter within redhat 8.0,
After boot,
I enter command "dmesg", the return information is like below:
divert: freeing divert_blk for eth0
eth0: Error EErpom read ffff
sis900.c v.1.08.04 4/25/2002
when i enter command "insmod sis900", the return infor is like this:
...including invalid IO or IRQ parameters. you may find more information
in syslog or the output from dmesg.
Pls help me how to solve this prob. Thank you very much.
/quan228228
.
Relevant Pages
- Re: Internet setup problem.
... What about the output of your ifconfig -a command? ... Does it list eth0 ... I'd also suggest checking dmesg. ... You should see an entry showing that eth0 becomes ready along with other info. ...
(Fedora) - Problem accessing HP Ultrium 2 tape drive.`
... I'm trying to use a HP Ultrium tape drive, with the following command (to ... Did rmmod then insmod. ... The last few lines of dmesg are as follows: ... Prev by Date: ...
(comp.os.linux.hardware) - Re: 3c59x problem with 2.4.6-test[34]
... PCI: PCI BIOS revision 2.10 entry at 0xfdb91, ... sym0:0:0: tagged command queuing enabled, ... eth0: ...
(Linux-Kernel) - Re: sis190
... local # dmesg ... eth0: Enabling Auto-negotiation. ... eth0: link change ... I had to reload sis190 (network restart was not sufficient). ...
(Linux-Kernel) - RE: eth0 not working
... I don't understand why but when I used the command below, ... logged in as root in order for the eth0 to work. ... The install went fine but for some reason, ... issue with the eth0 because when I went to shutdown the Kernel, ...
(Fedora) |
|
