Re: control system fan with software
- From: Magnus Warker <magnus@xxxxxxxxx>
- Date: Fri, 24 Nov 2006 04:53:26 +0100
Dear Michael,
thanks for your answer. In the meantime I wrote arbitrary numbers into the
files, without any recognizable changes in the FAN's speed.
Then, after a friend told me that, I wrote arbitrary numbers, which are
potencies of 2, without newlines (echo -n) into the files. But this also
resulted in no changes.
Then I looked again at the output of sensors-detect, and it told me that
k8temp is not available. I found that it is not part of my kernel (2.6.16)
and not part of the current stable version (2.6.18). It is part of the
kernel since 2.6.19.
Do you believe the missing module is the problem? If so, I would think about
installing the required kernel version, although it's a productive system.
Thanks a lot,
Magnus
.
- Follow-Ups:
- Re: control system fan with software
- From: Michael Mauch
- Re: control system fan with software
- References:
- control system fan with software
- From: Magnus Warker
- Re: control system fan with software
- From: Giovanni
- Re: control system fan with software
- From: Magnus Warker
- Re: control system fan with software
- From: Giovanni
- Re: control system fan with software
- From: Magnus Warker
- Re: control system fan with software
- From: Michael Mauch
- Re: control system fan with software
- From: Magnus Warker
- Re: control system fan with software
- From: Michael Mauch
- control system fan with software
- Prev by Date: Re: Are Uncorrectable Errors Acceptable? SMART thinks so.
- Next by Date: Re: how to acheive the synchronization in between the How to acheive the synchronization between existing driver and new kernel module.
- Previous by thread: Re: control system fan with software
- Next by thread: Re: control system fan with software
- Index(es):
Relevant Pages
|