Re: frequency out of range Ilyama E431S and Matrox G550 using DVI
- From: John-Paul Stewart <jpstewart@xxxxxxxxxxxxxxxx>
- Date: Mon, 23 Apr 2007 10:52:36 -0400
Vincent van Beveren wrote:
I have the following problem:
- When x starts I always get an 'out of range' message with horizontal 64kHz and vertical 60Hz. However these are well within the range of my monitor.
If you know that X is using values in the proper range for your monitor, yet your monitor complains about them being 'out of range', I would suspect a hardware problem. It could be as simple as a bad cable. It could an indicator that your monitor is not functioning properly. Or it could be that your graphics card is not putting out the sync signals properly.
Can you try a different monitor, or connect that monitor to a different computer? Trying a different cable is also worth a shot.
.
- References:
- frequency out of range Ilyama E431S and Matrox G550 using DVI
- From: Vincent van Beveren
- frequency out of range Ilyama E431S and Matrox G550 using DVI
- Prev by Date: Re: Another "What Motherboard Should I Buy" question
- Next by Date: Re: nothing works on ASUS M2R32-MVP
- Previous by thread: frequency out of range Ilyama E431S and Matrox G550 using DVI
- Index(es):
Relevant Pages
|
