Re: Nvidia sata 2.4

Hi,
Thanks for response !
This my lspci output:

00:00.0 Memory controller: nVidia Corporation: Unknown device 005e (rev a3)
00:01.0 ISA bridge: nVidia Corporation: Unknown device 0051 (rev a3)
00:01.1 SMBus: nVidia Corporation: Unknown device 0052 (rev a2)
00:02.0 USB Controller: nVidia Corporation: Unknown device 005a (rev a2)
00:02.1 USB Controller: nVidia Corporation: Unknown device 005b (rev a3)
00:06.0 IDE interface: nVidia Corporation: Unknown device 0053 (rev f2)
00:07.0 IDE interface: nVidia Corporation: Unknown device 0054 (rev f3)
00:08.0 IDE interface: nVidia Corporation: Unknown device 0055 (rev f3)
00:09.0 PCI bridge: nVidia Corporation: Unknown device 005c (rev a2)
00:0d.0 PCI bridge: nVidia Corporation: Unknown device 005d (rev a3)
00:0e.0 PCI bridge: nVidia Corporation: Unknown device 005d (rev a3)

I think it is same as your's.
What kernel you use? How much RAM?

Thanks,
Vitaly


Chris Cox wrote:
vitaly wrote:

Dear all,

we have a a computer Tyan K8SE .
with 4 cpus and 4G RAM, and SATA disk.
The kernel is 2.4.32 .
sometimes (about once a month) the computer stops responding with
following message:

I have a similar config... different mb... but also using
the Nvidia Pro 2200 chipset... can you do an lspci and see if
your SATA info matches mine?

00:06.0 IDE interface: nVidia Corporation CK804 IDE (rev a2)
00:07.0 IDE interface: nVidia Corporation CK804 Serial ATA Controller (rev a3)
00:08.0 IDE interface: nVidia Corporation CK804 Serial ATA Controller (rev a3)

My machine is dual 275's with 4G.... very similar to your config.

But I have never seen that message (but willing to say my machine
isn't on 24x7).
.

Relevant Pages

  • Re: Newbie Setting up xserver
    ... Could be, but now that I know that low memory is causing the problem, I will ... The kernel gobbles up the rest of the physical memory huh. ... Actually my RAM is split into two ... >it could be that some of the processes related to setting the timezone ...
    (comp.os.linux.setup)
  • Re: PCMCIA: unable to map memory
    ... MB RAM. ... Linux conflicts here with the pcmcia-controller. ... - A patch for the kernel (2.2. ... BadRAM by Rick van Rein (and it's successor BadMEM ...
    (comp.os.linux.portable)
  • Re: [PATCH] reserve RAM below PHYSICAL_START
    ... The "reserved RAM" can be mapped by virtualization software with to ... You're right but the relocatable kernel only works if you relocate it ... only works up to address near 1G, we can't reserve more than 1G with ...
    (Linux-Kernel)
  • Re: [BUG] 2.6.26-rc1 lost half the RAM on UltraSPARC 5
    ... Top of RAM: 0x17f46000, Total RAM: 0xff40000 ... Memory hole size: 128MB ... Kernel: Using 1 locked TLB entries for main kernel image. ... Movable zone start PFN for each node ...
    (Linux-Kernel)
  • Re: After executing MDCreateThread data abort occurs
    ... This is almost always RAM configuration, memory map, or cache problems. ... target.The code under Startup and KernelStart routines are running fine ... So the Kernel is not letting this address 0xc2000000 to be programmed. ...
    (microsoft.public.windowsce.embedded)