Re: Prob. installing Linux on Compaq Deskpro EP/SB Series

Schraalhans Keukenmeester wrote:
I just got a Deskpro EP/SB Series desktop system.
64MB RAM, NVidia 32MBVideocard, Realtek NIC, Celeron 400/66 processor.
(I am not worried about 'only' 64mb, this box will serve as firewall/router only, no graphical environment needed whatsoever.)

Installing windows has never been a problem according to previous owner.
Memory is tested and ok. CDROM (generic ATAPI) worked in other systems (including linux) w/o problems, HD is checked and ok.

Downloaded the BIOS config utility from HP, setup everything, all seems fine.

I tried FC -> failed, SuSE -> failed, Knoppix -> worked, and now I am trying Gentoo, from minimal install cd, I used that one succesfully on other boxen. Knoppix booted in expert mode _does_ properly mount the cd-drive. The other distros stopped without warning.

I can still boot the windows installation on the HD as well, diskchecks yielded nothing shocking.

Gentoo is most descriptive (ahem) during boot, and it seems to hang itself over a mount problem with the CDrom.

Gentoo loads kernel image, modules, then tries mounting the CD as hda, hda1, then hdb (hdc when set as master on ide2, hdd when slave). That's when it halts, after the cursor moves exactly 2 places to the right (following a ~30sec silent period). Completely dead afterwards. Keyb, tutti. I am not sure but think it is likely the other distros have a similar problem. It should recognize it as /dev/hdb (or hdc/hdd when set to ide2) I suppose.
[snap]

Fixed. DMA issue after all. Disabling it in BIOS for cdrom was not enough. Booted with option ide=nodma, now it runs.

KR
Sh
.

Relevant Pages

  • Re: Converting to Linux
    ... >> process, especially for installing Gentoo. ... > chainging to another distro as I have all to much other stuff that I would ... > upgrading or installing something new. ... Mandrake will barf and explode on ...
    (alt.linux)
  • CDrom order for 7.04 server
    ... are different between booting from CD and installing and booting from the ... My setup has 11 cdrom devices as follows: ... I booted from the dvd burner. ...
    (Ubuntu)
  • Re: [Ubuntu Chicago] Question about Ubuntu.
    ... Kendall Brown wrote: ... recently and was hoping to use towards installing Ubuntu on my ... Any way...I wanted to know why Gentoo was able to load onto my ... enter this command in a Ubuntu installation so I can test it out? ...
    (Ubuntu)
  • Re: XP Setup hangs with dual PIII-550 on Asus P2B-DS v1.04
    ... In my case it turned out to be the CDROM XP was installing from. ... > have not made any hardware modifications to the board. ... The setup hangs somewhere after ...
    (alt.comp.periphs.mainboard.asus)
  • RE: IBM 325 Server install - hangs on scsi settle
    ... Changes to PC Bios before installing FBSD ... Check to see if the cdrom drive is the slave to the IDE master Hard ... Keep in mind that some older CD-ROMs drives ...
    (freebsd-questions)