Re: rpc.statd WHAT IS IT ?????????

On May 31, 1:02 pm, Shadow_7 <wwwShad...@xxxxxxxxxxxxxxx> wrote:
apt-get install rcconf

Hmmm. I'm not familiar with that tool. I normally manually edit my
services/daemons that run at boot. Generally by rm-ing the entries in /
etc/rc?.d/.

As far as rpc.statd, I believe that it gets started by portmap. Which is
odd since it doesn't get stopped when you stop portmap.

on my system i disabled it by disabling /ect/rc5.d/Sxxnfs-common

rcconf renamed it to /etc/rc5.d/K00nfs-common

i rebooted and rpc.statd was no longer a running process

.

Relevant Pages

  • first bisection results in -mm3 [was: Re: 2.6.15-mm2: reiser3 oops on suspend and more (bonu
    ... first bisection spotted the cause of the stalls at boot (happening while ... are somewhat related) fixes the stalls I experience. ... sda: assuming drive cache: write through ... Starting portmap daemon: portmap. ...
    (Linux-Kernel)
  • Re: [SLE] -- Install Problem #2 -- no portmapper
    ... Did you get the boot log messages? ... Sent the entire boot file to andjoh@rydsbo.net. ... failure in the chain of failures is "portmap". ... If it is running during the current session ...
    (SuSE)
  • portmap issue in FC3
    ... i discovered one of your discussion about portmap in linux. ... Currently i'm using FC3 and my portmap cannot start at boot up. ...
    (freebsd-questions)
  • Slow portmapper startup
    ... passwd: nis files ... the portmap service startup during boot takes a ... In a way that makes sense, since ypbind is started after ... portmap, but is there a way to avoid it? ...
    (RedHat)