Re: how can a bit be off in memory?



ray <ray@xxxxxxxxxx> did eloquently scribble:
On Fri, 29 Jun 2007 23:58:48 +0200, Charles T. Smith wrote:

Vim started crashing on me, particularly when I tried to open new lines.
I finally checked it out with rpm and a newly downloaded copy of vim's
rpm and discovered that exactly one byte, deep into vim, was wrong.

I rebooted my machine (which has been super-solid for years) - and the
difference was gone.

So, what are the opinions - did I run into a hardware glich, or was
there a freaky issue with memory mapping?

I think I'd run 'badblocks' on the disk.

Or turn swap off and remake it with -c?
--
______________________________________________________________________________
| spike1@xxxxxxxxxxxxx | |
|Andrew Halliwell BSc(hons)| "The day Microsoft makes something that doesn't |
| in | suck is probably the day they start making |
| Computer science | vacuum cleaners" - Ernst Jan Plugge |
------------------------------------------------------------------------------
.



Relevant Pages

  • Re: 01 camry rubber smell
    ... Ray O wrote: ... How high does engine RPM go when you start the engine? ... Can you smell the "rubber odor" from inside the passenger compartment ...
    (alt.autos.toyota)
  • Re: 01 camry rubber smell
    ... Ray O wrote: ... How high does engine RPM go when you start the engine? ... Can you smell the "rubber odor" from inside the passenger compartment ...
    (alt.autos.toyota)
  • Re: 01 camry rubber smell
    ... Ray O wrote: ... How high does engine RPM go when you start the engine? ... Can you smell the "rubber odor" from inside the passenger compartment ... the thing is i never have my foot on the throttle when turning ignition ...
    (alt.autos.toyota)
  • Re: 83 Celica Poor mpg/power
    ... engine RPM, the timing should advance in a pretty linear fashion. ... Hey, Ray, on this car it's one of those green 2-pole connectors, located ... headlight manual knob. ...
    (alt.autos.toyota)
  • Re: Recommendations for a high speed spindle
    ... It involves cutting a number of long grooves about 3/16 in. ... and .137 deep. ... The machine now turns only 3500 rpm. ... The precise spindles are pricey and the HP isn't too high for the base ...
    (alt.machines.cnc)