Multiple NICS issue
From: MTS News Server (rgaudet77_at_hotmail.com)
Date: 07/24/03
- Next message: David Johnstone: "Re: NIS Problem Suse/AIX (Domains?)"
- Previous message: Ian Northeast: "Re: Trouble with multiple ethernet cards"
- Next in thread: /dev/rob0: "Re: Multiple NICS issue"
- Reply: /dev/rob0: "Re: Multiple NICS issue"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Thu, 24 Jul 2003 15:34:37 -0500
Hi,
I just finished installing RH9 with two NICS and I'm trying to figure out
how to set up my NICS properly. Here's how it should work;
eth0 is configured to use dhcp where is obtains an IP from my dhcp server
and will be used to access network resources (default gateway
192.168.0.201). eth1 is configured to use dhcp from a PPPoE router and will
be used to internet access (gateway 10.0.0.1). The reason for using the
PPPoE router for internet access is becuase my primary network uses
Microsoft ISA server and I can't authenticate to it through Linux. Also,
ETH1 is used to accept incoming request to the Linux box (FTP,SSH and backup
mail server) eth1 is not a trusted device. Both devices are getting correct
IPs.
What is happening is I can connect to my local network (192.168.0.*) but
when I try to access the internet, the request is trying to go through the
ISA server instead of the PPPoE router.
Can anyone offer any suggestions?
ifconfig output:
eth0 Link encap:Ethernet HWaddr 00:30:84:88:56:1D
inet addr:192.168.0.116 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:44809 errors:0 dropped:0 overruns:0 frame:0
TX packets:32199 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:57185167 (54.5 Mb) TX bytes:3365880 (3.2 Mb)
Interrupt:9 Base address:0xd000
eth1 Link encap:Ethernet HWaddr 00:E0:7D:D1:0F:E4
inet addr:10.0.0.19 Bcast:255.255.255.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1201 errors:0 dropped:0 overruns:0 frame:0
TX packets:1304 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:496312 (484.6 Kb) TX bytes:156830 (153.1 Kb)
Interrupt:10 Base address:0x7000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:56055 errors:0 dropped:0 overruns:0 frame:0
TX packets:56055 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3827464 (3.6 Mb) TX bytes:3827464 (3.6 Mb)
Route output:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.0.0.0 * 255.255.255.0 U 0 0 0 eth1
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth1
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 192.168.0.201 0.0.0.0 UG 0 0 0 eth0
Thanks in advance
- Next message: David Johnstone: "Re: NIS Problem Suse/AIX (Domains?)"
- Previous message: Ian Northeast: "Re: Trouble with multiple ethernet cards"
- Next in thread: /dev/rob0: "Re: Multiple NICS issue"
- Reply: /dev/rob0: "Re: Multiple NICS issue"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
