Re: Suspicious network traffic.
Date: 20 Apr 2004 21:42:30 -0500
In article <firstname.lastname@example.org> moorhuhn <email@example.com> wrote:
>>From mrtg, I found a constant 2 MBytes "incoming" traffic coming into
>eth0 every 5 minutes.
>How can I debug/fix this problem? I need to know why this eth0 RX
>value increased about 2 MBytes every 5 minutes ...
>Anyone know how to trace this problem?
Install and use http://freshmeat.net/projects/iftop/ to see what's happening.
use hotmail for any email replies
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----
- Re: A lot of problems with debian sid on a Notebook
... Both entrys have a pae, my question is: can I remove the ...-2-686-pae entry? ... I needed a few time to set up eth0. ... Wiki and internet are full of informations about that, but, in short, enable contrib and non-free repo in your /etc/apt/sources.list, know your hardware with $lspci or $lsusb and you should have enough informations to discover what you need to install. ... Than I set up eth0 but wlan0 doesn't works and the network manager meant I have no connection, I think thats the reason, why pidgin isn't connecting. ...
- NIC problems, speed or driver?
... The install automatically loaded the 3c59x driver: ... eth0: Dropping NETIF_F_SG since no checksum feature. ... Transmit error, Tx status register d0. ...
- Lost all network connectivity after clean FC3 install
... I had a decently working FC1 install on my PC. ... network cards on my PC (eth0 and eth1). ... eth0 is connected to a Motorola SB5100 cable modem. ... a home LAN and internet connectivity are ...
- Re: FC6 not connecting -- amplification
... All right, making assurance doubly sure, I logged in using "su - root" ... I think I just gave up, wiped that install with DBAN, ... Run "ifconfig" and verify you have device eth0. ...
- Re: Newbie problem - Ethernet card configuration
... > Looks like dhcpd is not installed. ... > # yum install dhcp ... and i am getting Broadcom set for eth0. ...