serial interface to ethernet interface

From: Kenneth Sparre (ksso03_at_control.auc.dk)
Date: 10/28/05 

Date: Fri, 28 Oct 2005 08:20:25 +0200

Is it possible to make a serial interface looked like a ethernet
interface? This is necessary because I have to bridge the serial
interface with my WLAN connection.

Best Regards
Kenneth

Relevant Pages

  • Re: Radionics D7212 logging
    ... D9133 serial interface module to talk rs232 to it. ... panel that can use the same sensors since I'm looking at buying ... I kind of thought you were looking to do some kind of automation ...
    (alt.security.alarms)
  • Re: Radionics D7212 logging
    ... D9133 serial interface module to talk rs232 to it. ... panel that can use the same sensors since I'm looking at buying ... I kind of thought you were looking to do some kind of automation ...
    (alt.security.alarms)
  • Re: Cisco T1 Internet Config
    ... If the line is functioning properly with this config, ... I personally would not have used a sub interface in this case as you only ... ip unnumbered command would have moved to the serial interface. ... encapsulation frame-relay IETF -- Do I need this line? ...
    (comp.dcom.sys.cisco)
  • Re: Channelised ISDN E1/PRI and serial interfaces number
    ... "real serial interface", Serial0/0 ... ISDN D channel interface in your PRI, ...
    (comp.dcom.sys.cisco)
  • Re: Configuring Cisco for PPP T1
    ... > The T1 is currently running on a serial interface connected to an ... > WIC card will not work. ... > interface Serial0/0 ... Basic things, issue the "no shut" command in interface config mode, check ...
    (comp.dcom.sys.cisco)