Re: Can't get WiFi to work
- From: Jim R <flaflashr@xxxxxxxxxxx>
- Date: Thu, 30 Mar 2006 11:37:19 -0500
Unruh wrote:
JimR <kd1yv@xxxxxxxx> writes:{snip}
I just installed Suse 10.0 as dual-boot with Win/2000 on an IBM Thinkpad
T23. I am trying to use a Linksys WPC11 v4 pcmcia. Under Win/2000, it
works perfectly (same machine, same AP, same WEP encryption, etc.)
(none):~ # iwlist s
You are not connected to any access point. What do you get if you do
iwlist s
lo Interface doesn't support scanning.
sit0 Interface doesn't support scanning.
wifi0 No scan results
wlan0 No scan results
eth0 Interface doesn't support scanning.
wlan1 Scan completed :
Cell 01 - Address: 00:12:17:6D:7B:CA
ESSID:""
Mode:Master
Frequency:2.462 GHz (Channel 11)
Bit Rate:1 Mb/s
Bit Rate:2 Mb/s
Bit Rate:5.5 Mb/s
Bit Rate:11 Mb/s
Bit Rate:18 Mb/s
Bit Rate:24 Mb/s
Bit Rate:36 Mb/s
Bit Rate:54 Mb/s
Quality=1/100 Signal level=-31 dBm Noise level=-256 dBm
Encryption key:on
{snip}
wlan0 device: Intersil Corporation Prism 2.5 Wavelan chipset
(rev 01)
wlan0 No configuration found for wlan0
unused
wlan1 device: Realtek Semiconductor Co., Ltd. RTL8180L 802.11b
MAC (rev 20)
How many wireless cards do you have?
Only 1 wireless "card" (pcmcia). The Thinkpad has a builtin infrared port, which Suse also considers to be a wireless device at wlan0. I have never used the IR, but it is, nevertheless, installed.
73 de Jim
.
- References:
- Can't get WiFi to work
- From: JimR
- Re: Can't get WiFi to work
- From: Unruh
- Can't get WiFi to work
- Prev by Date: Re: how can i get more bandwidth?
- Next by Date: Re: Can't get WiFi to work
- Previous by thread: Re: Can't get WiFi to work
- Next by thread: Re: Can't get WiFi to work
- Index(es):
Relevant Pages
|
