Re: Enabling the Intel 82562ET Nic

Greg Tracy wrote:
Tauno Voipio wrote:

Greg Tracy wrote:


I've been struggling through a new Suse 10.1 install. Actually, everything has gone well accept for my network configuration.

I'm running the following...

NIC: "HP 82562ET/EZ/GT/GZ - PRO/100 VE (LOM)
Kernel: 2.6.16.13-4

During the standard YaST install procedure, the card is detected, and seemingly correctly configures the module name to e100. I have it configured to use DHCP to acquire an address. However, during the internet connection test, it fails to get out (no IP address is obtained). The log displayed during this workflow says,

"DHCP client is already running on eth0"

1. After completing the installation, the card does appear to be working partially. The loopback interface is up and I can ping localhost.


This *does not* prove anything about the NIC - the IP stack
is smart enough to route accesses to *any* of the local IP
addresses via the loopback interface.


I've since learned that the loopback works even without a NIC card physically present...

Please verify the presence of the interface with

ifconfig -a


I'd print it here if it were easy, but you'll have to trust me that the interface is present.

This means that the driver is probably OK, let's bark
at other trees in the meantime.

Do the cable link LEDs light at the NIC and the box at
the other end?


No lights at the other end of the tunnel....

If there are link LEDs which do not light, you do have
cabling problems. Maybe you need a crossed Ethernet cable
instead of the straight one.

--

Tauno Voipio
tauno voipio (at) iki fi
.

Relevant Pages

  • Re: Enabling the Intel 82562ET Nic
    ... everything has gone well accept for my network configuration. ... During the standard YaST install procedure, the card is detected, and seemingly correctly configures the module name to e100. ... The loopback interface is up and I can ping localhost. ...
    (comp.os.linux.networking)
  • Re: Enabling the Intel 82562ET Nic
    ... During the standard YaST install procedure, the card is detected, and seemingly correctly configures the module name to e100. ... I have it configured to use DHCP to acquire an address. ... The loopback interface is up and I can ping localhost. ... etc.) in my linksys router configuration that would explain the lack of an IP address being served up. ...
    (comp.os.linux.networking)
  • Re: Enabling the Intel 82562ET Nic
    ... During the standard YaST install procedure, the card is detected, and seemingly correctly configures the module name to e100. ... I have it configured to use DHCP to acquire an address. ... The loopback interface is up and I can ping localhost. ... etc.) in my linksys router configuration that would explain the lack of an IP address being served up. ...
    (comp.os.linux.networking)
  • Open-Suse 10.2
    ... Biggest problem I have is getting the Wifi to work. ... from their website on (both madwfi and ndiswrapper). ... file for my wireless card via ndiswrapper. ... network configuration and followed the examples I read and set up my ...
    (alt.os.linux.suse)
  • Re: Linux-compatible wireless access cards
    ... It looks like I've got a problem with my Edimax card and Mandriva 2005LE, ... If I go into the MDV network configuration and hit the "OK" button it ... to do some serious investigation or set up Serialmonkey and try that. ...
    (uk.comp.os.linux)