Router--IPCOP--Switch--LAN

Hi,

I have a problem.

My network is this: Router--eth1(IPCOP)eth0--Switch--LAN

The IPCOP have two interfaces eth1 to router and eth0 to switch.
From the LAN dont arrive to router and havent exit to internet.

From the Lan arrive to IPCOP and eth0 but dont arrive to eth1.

From the IPCOP arrive to all sites, internet, LAN.

I put here some data:

1) Router Comtrend 536:

* Formed like multiposition
* IP to acces to router: 192.168.1.1 y la 192.168.2.1

2) Ipcop (Green+Red):

* Interface RED:

eth1: 192.168.2.5
GW: 192.168.2.1

* Interface GREEN:

eth0: 192.168.1.5

The problem this in the router?

Thanks.

.

Relevant Pages

  • [Full-Disclosure] FW: Cisco Vulnerability forensic protocol analysis results.
    ... AMILABS CISCO IP PROTOCOL EXPLOIT TESTING RESULTS ... Cisco router interfaces using either all or one of the following IP ... of a remote Cisco interface uses all of them. ... output buffer failures, 0 output buffers swapped out Router4# ...
    (Full-Disclosure)
  • Re: Router--IPCOP--Switch--LAN
    ... Couldn't it be that replies from the router or the internet don't arrive to the IPCOP? ... Interface GREEN: ... Does the IPCOP do masquerading or source NAT for the LAN on the RED interface? ...
    (comp.os.linux.networking)
  • Re: Site-to-Site VPN client routing question - clients at branch office not able to acce
    ... I would recommend that you use some other machine as your router, ... select the demand-dial interface from the dropdown list. ... On the RRAS server in Shanghai, configure a demand-dial interface and give it a static route to 194.1.1.0/24 as above. ... This makes sure that the connection is made to the correct dd interface and sets up the correct route back to Shanghai through the VPN link. ...
    (microsoft.public.windows.server.networking)
  • Point to Point T1 with Cisco 1841 Routers
    ... checked it in the morning and on my side, the router had a lot of CRC ... interface FastEthernet0/0 ... ip http access-class 23 ... minute output rate 0 bits/sec, 0 packets/sec ...
    (comp.dcom.sys.cisco)
  • Re: moved a working network, now it doesnt work
    ... router I can ping the internet with no problem. ... From one of your Linux machines can you ping the FA 0/1 interface (default ... are NOT natting so if CAN ping from the router, ...
    (comp.dcom.sys.cisco)