Re: connection problem with DSL modem.


I bought a D-Link DI-604 router after work.
It did not give any instruction for Linux user but, it worked out for
me.

Assigned the private IP to the network card.
Then, cloned the MAC address of the network card to the router and
connected to ISP.

Everything works fine now.




Robert Harris 작성:

nabi wrote:
I've spent two days so far to connect my Linux box with DSL modem from
Telus.
I have 2.4.1 PPPoE client: pppoe, pppd and running scipts (adsl-start,
adsl-stop, etc.).
I used to use Sympatico without any problem until 2005 in Ontario.

How does your DSL modem connect to your computer? e.g. is it a PCI card
or does it connect to your USB or ethernet port?

And, if it really stays difficult, remember that for £30 you can buy a
combined ADSL modem and ethernet router that will plug into an ethernet
port which will allow you to forget all about ppp and adls-* scripts.

Robert

[snip]


.

Relevant Pages

  • Re: Router with 2 ethernet ports
    ... Is there a router available that has 2 ethernet ports so each port can ... All the routers I see have 1 ethernet port and serial ports. ... have both subnets assigned to the single interface and then route from ...
    (comp.dcom.sys.cisco)
  • Re: Zoom ADSL /router Fedora Home Lan SETUP HELP Fedora4 /WinXP ;
    ... > Both are connected via ethernet to a ZOOM adsl router and the router is ... > obviously connected to a hub/switch from which the two separate ethernet ... > cables go to the two separate ethernet cards on the two separate computers. ... take anything that arrives on the Ethernet port and send it ...
    (Fedora)
  • Re: Strange Network Problem
    ... I'm not sure what line the line tester would be testing. ... inside that one router port is OK. ... desktop computer - again using only exact same ethernet cables. ...
    (microsoft.public.windowsxp.network_web)
  • Re: Windows XP Networking Problems - Solution
    ... >>included with the PA301/101 acts as a software router. ... >>My suggestion would be, as I repeat over and over, to use an Ethernet ... You wouldn't have to replace or bridge both ... you'll need an Ethernet to HPNA bridge on the router end. ...
    (microsoft.public.windowsxp.network_web)
  • Re: gateway IP address
    ... than one other node connected to the Ethernet so just having one way ... connecting his PC to the router, ... Ethernet is going to be the "gateway". ... This will show how MAC addresses ...
    (comp.dcom.sys.cisco)