Re: Linksys Wireless Router 2.4-GHz, Ubuntu, not working

On 11 Jun, 02:43, Timothy Murphy <t...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
Dawson wrote:
On 10 Jun, 14:33, Dawson <costel...@xxxxxxxxx> wrote:
Hi, I've just bought a Linksys Wireless ADSL Router, attached it to my
laptop via RJ45 cable, setup and all working fine! However, although I
can see the SID being broadcast, it's telling me connection failed --
I have put in the correct WEP key as per the router administration but
it's still not working. I've tried everything but can only get online
via the hard-wire cable :(

Right, further investigations. I have disabled the WEP key and allowed
anonymous access and it's still telling me connection failed? any
ideas? Thank you

What does iwconfig say?
And "iwlist scan ..."?

--
Timothy Murphy
e-mail (<80k only): tim /at/ birdsnest.maths.tcd.ie
tel: +353-86-2336090, +353-1-2842366
s-mail: School of Mathematics, Trinity College, Dublin 2, Ireland

dawson@dawson-laptop:~$ iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

eth1 unassociated ESSID:"hippy_commune"
Mode:Managed Frequency=nan kHz Access Point: Not-
Associated
Bit Rate:0 kb/s Tx-Power:16 dBm
Retry limit:15 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:5483 Missed beacon:0



--------------------------------------------------


dawson@dawson-laptop:~$ iwlist scan
lo Interface doesn't support scanning.

eth0 Interface doesn't support scanning.

eth1 Scan completed :
Cell 01 - Address: 00:13:10:DB:3B:CD
ESSID:"hippy_commune"
Protocol:IEEE 802.11bg
Mode:Master
Channel:6
Encryption key:off
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
11 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36
Mb/s
48 Mb/s; 54 Mb/s
Quality=92/100 Signal level=-39 dBm Noise
level=-39 dBm
Extra: Last beacon: 480ms ago

.

Relevant Pages

  • Problem with bcm43xx-80211 Revisited Again
    ... If I run 'ifup eth1', ... of Wireless Extension, while this program supports up to version 20. ... 12 Mb/s; 48 Mb/s ... Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 ...
    (Fedora)
  • Re: I Read People leaving Be.
    ... Technology should be judged by how well it works, not by inner details ... I'm not one of these speed obsessives, who seem to only use their internet connection to constantly measure and worry about every b/s of their speed, but general surfing is actually no different, the only change I've noticed in day to day use is that BBC iplayer doesn't stutter when I'm watching at the same time others in the house are surfing. ... Depending when I run a speed test, I get anything from 14 to 29 Mb/s, downloading update files etc, I rarely get more than 8 Mb/s. ... Please replace invalid and invalid with gmx and net to reply. ...
    (uk.telecom.broadband)
  • Re: Trouble installing Linksys WMP54G wireless PCI adapter Fedora 8
    ... Subsystem: RaLink Unknown device 2561 ... wlan0 IEEE 802.11g ESSID:"" ... Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 ... 12 Mb/s; 48 Mb/s ...
    (Fedora)
  • Re: inksys wireless network card for notebook . no internet
    ... The next thing I did was to install Ndiswrapper I then installed the lsbcmnds.inf from the linksys cd. ... I tested ndiswrapper and it stated that driver and hardware was installed at this point the power light on the network card came on. ... Bit Rate:1 Mb/s ... Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 ...
    (alt.os.linux)
  • 2.6.18-rc1: zd1211rw doesnt work yet?
    ... wlan0 802.11g zd1211 ESSID:"" ... Mode:Managed Frequency:2.412 GHz Access Point: Invalid ... I had expected something like this (running iwconfig for 2.6.17.3 ... Bit Rate:54 Mb/s ...
    (Linux-Kernel)