Re: 1000mbps connection problem between Linux and Solaris

On Oct 25, 8:56 pm, Vishal Sharma <visha...@xxxxxxxxx> wrote:

The Solaris Box has 2 NIC's one with IP Address 10.10.10.8 (this is
connected to the switch and is at 100mbps full duplex) and another
with IP Address 192.168.1.2 (this is connected to the Linux Box using
a cross over Cat6 Cable and is at 100mbps full duplex). Both are ce
interfaces. ce0 and ce1.

Was your Cat6 crossover cable specifically intended for GigE use? Was
it wired by someone who knows how to wire a GigE crossover cable? I'll
bet you have an FE crossover cable, not a GE crossover cable.

DS

.

Relevant Pages

  • Re: FTP very slow send but fast get
    ... >> the duplex state of each line? ... > and I don't see anything on the switch that indicates the duplex mode of the ... the media setting for a Linux ethernet interface from the shell prompt. ...
    (alt.os.linux)
  • Re: [SLE] Network problems Help!!!!
    ... Your gateway is the box that has the NIC for the outside world, ... can you ping the NT box from the Linux box. ... NIC and switch are working. ... (Most switches will handle both full and half duplex where hubs are only ...
    (SuSE)
  • Re: two NICs and speed issues
    ... > So if you disconnect the modem the transfers are fast on the ... > will give you a listing of each interface. ... > connections you want to have full duplex set. ... > between the NIC and the switch you will see the error count increase ...
    (Fedora)
  • Re: Mysterious problem on my clients Windows Server 2003 Network
    ... I changed the switch today and I'm still getting the bad checksums. ... cable is configured to 100Mbps full duplex and the other end to ... would lose connection to the server and/or connection to the internet, ...
    (microsoft.public.windows.server.networking)
  • Re: Odd Duplex Problem - transmit speed
    ... I have a GE medical imaging device that GE tells me HAS to be ... Easy enough, affer the switch config, I check the GE Imaging device, ... and plug a small dlink hub into that port. ... A HUB cannot operate at full duplex, it is a hub, it only runs at half ...
    (comp.dcom.sys.cisco)