Re: 440GX Ocotea IBM Emac driver "Cant find PHY" Error
From: Srinivas Murthy (the.srinivas_at_gmail.com)
Date: 05/31/05
- Next message: larwe_at_larwe.com: "Re: 16bpp graphics modes on old iMac, what is the MSB function?"
- Previous message: Arun Prasad Velu: "Re: Urgent Requirement for Linux Developers!"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Tue, 31 May 2005 13:08:42 -0700
Just FYI,
The problem was that the board-level registers FPGA_REG0 - FPGA_REG4 need to
be initialized after a soft/hard reset to get the EMAC's to work.
-Srinivas
"Srinivas Murthy" <the.srinivas@gmail.com> wrote in message
news:1116834693.705896@cswreg.cos.agilent.com...
> Hi,
> I'm having a problem on my IBM 440GX Ocotea board with the ibm emac
> driver complaining "Cant find PHY" for Emac's 0 - 3.
>
> I see that the emac_phy_read() function ouputs "timeout #1" error
> message causing the "Cant find PHY" error message for each of the 4 MAC's
on
> the chip.
>
> I would think that some register/s on the board related to the
ethernet
> MAC 0 are messed up on my config and am not able to isolate the problem.
>
> Can anyone provide any pointers for me to isolate the problem?
>
> I know that there is nothing wrong with the hw itself since I can run
> the same board with a different configuration and the same linux kernel
> image.
>
> Thanks.
>
>
- Next message: larwe_at_larwe.com: "Re: 16bpp graphics modes on old iMac, what is the MSB function?"
- Previous message: Arun Prasad Velu: "Re: Urgent Requirement for Linux Developers!"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
