Re: iBook suspend

Some more information: my iBook in fact seems to suspend, but does not
wake up. Instead I get a screen full of error messages I cannot find
anywhere under /var/log:

eth0: suspending, WakeOnLan disabled
pci_set_powerstate(): 0002:20:0e.0: state= 3, current state=5
firewire_ohci:pci_set_power_state failed with -22
Machine check in kernel mode.
Caused by ((from SRR1=4b030)): Transfer error ack signal
Oops: Machine check, sig: 7 [#1]
PowerMac
Modules linked in: lp parport cpufreq_powersave [etc.... ............. ]

NIP: d903103c LR: d9031378 CTR: c010d214
REGS: d6411cf0 TRAP: 0200 Not tainted (2.6.22-3-powerpc)
MSR: 0004b030 <EE,FP,ME,IR,DR< CR: 28004244 XER: 200000000
GPR00: <followed by lines of hexadecimals
GPR08: ...........
GPR16: ............
GPR24: .............>

NIP [d903103c] software_reset+0x3c/0x80 [fireqire_ohci]
LR [d9031378] ohci_enable+0x2c/0x318 [firewire_ohci]

and so on....

It all ends with Exception: c01 at 0xfac65cc
LR = 0xfac6530

and an instruction dump with two lines of hexadecimals.

I tried to suspend the laptop after killing hald, but it did not help at
all. What else should I try? Another kernel?

--
--
http://www.helsinki.fi/~piippo

.

Relevant Pages

  • 2.6.30-rc1: touchpad disabled on hibernation
    ... The synaptics touchpad on my EeePC 701 dies on hibernation. ... and it doesn't happen on suspend to ram either. ... obvious error messages, but maybe this boot message is relevant: ...
    (Linux-Kernel)
  • VMProcessPageFault Error?
    ... I use WinCE6.0 R2 + BinFS in my platfrom, ... error messages like below when I do SUSPEND and RESUME. ... Page fault occurred while in power handler! ...
    (microsoft.public.windowsce.platbuilder)