Getting a Neovo E19-a LCD to work under X

From: Christopher Auld (auld_at_acs.ucalgary.ca)
Date: 06/16/04

  • Next message: rockwell: "adding a screensaver" 
    Date: 16 Jun 2004 12:24:48 -0600

    Trying to install this LCD under Fedora core 1 on a machine with a GeForce
    4/4200 card. The installer correctly identifies the monitor, and the sync
    ranges it chooses match the manufacturer's specs. But the monitor displays
    "input signal out of range" when I try to start X. I tried fixing the
    syncs at 60, turning down the color depth, and various resolutions to no
    avail.

    X does work when I fire up Knoppix 3.4, but it won't run at the panel's
    native resolution of 1280x1024, so using those settings is not a solution.

    Thanks for any tips. 

    -- 
M. Christopher Auld            auld@ucalgary.ca
Assistant Professor            <http://jerry.ss.ucalgary.ca>
Department of Economics        voice: 1.403.220.4098
University of Calgary          FAX:   1.403.282.5262
  • Next message: rockwell: "adding a screensaver"

    Relevant Pages

    • Re: Apple //e RGB Card to CGA pinout?
      ... it can use composite sync on the same terminal which is Horizontal when using separated syncs. ... I read in the Mitsubishi manual that it should be possible to have the syncs composite on the green input too, but that doesn't work because then the normal monocrome video output should work on the green input. ... I then made a quick adapter for the mitsubishi monitor without the resistors to display "8 colors". ... If you already connected CGA monitor to PC and it is working fine with no problem, then the configuration from Apple //e RGB card to CGA monitor is wrong according to my theory. ...
      (comp.sys.apple2)
    • Re: Apple //e RGB Card to CGA pinout?
      ... it can use composite sync on the same terminal which is Horizontal when using separated syncs. ... Either there is a problem with the levels or the monitor might be broken (I will open it and see if there is anything to adjust. ... If you already connected CGA monitor to PC and it is working fine with no problem, then the configuration from Apple //e RGB card to CGA monitor is wrong according to my theory. ... I will proceed later today to investigate with an oscilloscope and compare the signals from the apple with the signals from the cga card. ...
      (comp.sys.apple2)
    • Sega Turbo Monitor questions - was Monitor first? Newbie needs help on a restoration?
      ... is a shroud, a black plexi that screws into the shroud and the bezel IIRC. ... Those wires are power, video signal and sync. ... and the monitor is alive. ... I'm going to have to splice into the video cables anyway. ...
      (rec.games.video.arcade.collecting)
    • Re: Will this idea work? (3D view)
      ... mount one on both sides of the stereo microscope, and frame sequentially display ... You would have some problem keeping the two video sources in sync. ... And than optionally lock the color subcarriers if I wanted to go directly to an analog color set. ... I would find looking through a monitor to be annoying since you ...
      (sci.electronics.design)
    • Re: Help with an RGB Conversion...
      ... newer VGA monitor in a number of ways. ... Sync we do see staticy Horizontal lines of that color. ... using a Single BNC to Single BNC cable, if we connect this cable to the ... I'm looking for the most cost effective solution. ...
      (sci.electronics.design)