Re: Changing refresh rate

From: Bill Marcum (bmarcum_at_iglou.com.urgent)
Date: 03/21/05

  • Next message: Martin Stenzel: "Re: fglrx drama"
    Date: Mon, 21 Mar 2005 15:06:08 -0500
    
    

    On 21 Mar 2005 07:37:46 -0800, petermcmillan_uk@yahoo.com
      <petermcmillan_uk@yahoo.com> wrote:
    >
    > Argh, I just tried adding a modeline, and it messed up. It went to
    > 1280x1024 @ almost 150Hz :-o. The vertical rate was fine, but the
    > Horizontal was 134KHz, which is 2KHz more than my monitor can do. So
    > I'm not sure what to do. My monitor didn't complain or anything
    > though, and it was nice to see it not flickering for once. I obviously
    > don't like to run it higher than my monitor can take, I was aiming for
    > 100Hz :-(
    >
    Make sure the HorizSync and VRefresh lines in your XF86Config or
    XOrgConfig file match your monitor's capabilities.


  • Next message: Martin Stenzel: "Re: fglrx drama"

    Relevant Pages

    • Re: Changing refresh rate
      ... Bill Marcum wrote: ... >> Argh, I just tried adding a modeline, and it messed up. ... My monitor didn't complain or anything ...
      (comp.os.linux.x)
    • Re: Why I am prejudiced
      ... > resolution on my 17" monitor. ... Anything bigger requires me to scroll. ... Before you complain too loudly... ...
      (comp.sys.ibm.ps2.hardware)
    • Re: Rare Entries MSB52: Results
      ... Mark Brader wrote: ... It's not obvious at all on my monitor. ... It's got a little bit of a tint to it, but that's not at all what I would think of as 'strongly colored.' ... Usually I complain about my own results. ...
      (rec.puzzles)
    • Re: Changing refresh rate
      ... > the Black Sun and said: ... >> Argh, I just tried adding a modeline, and it messed up. ... but I'm supprised my monitor didn't complain though:-o ...
      (comp.os.linux.x)
    • Re: This newsgroup is stupid
      ... intend to complain to the SEC this afternoon and request they monitor and ... go after every bullshit phoney claim they see. ...
      (misc.invest.stocks)