X config Gateway M500 display
From: Matt Wette (Matthew.R.Wette_at_jpl.nasa.gov)
Date: 10/28/03
- Next message: Bogdan: "Linux on Panasonic CF-73"
- Previous message: Steve Roy: "Re: Open source mail server on windows, oh my..."
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 28 Oct 2003 10:24:56 -0800
I purchased a new Gateway M500 notebook. I'm running RH9 with
the nvidia driver from nvidia.com, for the GeForce 420 Go 32M
board. The notebook has a 1280x854 display. I can't seem to
configure X (XF86Config) to get this to work. I'd appreciate
any help or pointers anyone might be willing to provide. -- Matt
Based on the info contained below (excerpts from XFre86.log after
running X with "-verbose 5 -logverbose 5") I set up a ModeLine for the
monitor as follows:
ModeLine "1280x854" 80.0 1280 1328 1440 1688 854 855 858 866
However, it still doesn't work (adding the nvidia driver did
enable 1024x768 though).
XFree86 Version 4.3.0 (Red Hat Linux release: 4.3.0-2)
Release Date: 27 February 2003
X Protocol Version 11, Revision 0, Release 6.6
Build Operating System: Linux 2.4.20-3bigmem i686 [ELF]
Build Date: 27 February 2003
Build Host: porky.devel.redhat.com
[...]
(**) NVIDIA(0): Depth 16, (--) framebuffer bpp 16
(==) NVIDIA(0): RGB weight 565
(==) NVIDIA(0): Default visual is TrueColor
(==) NVIDIA(0): Using gamma correction (1.0, 1.0, 1.0)
(==) NVIDIA(0): Using HW cursor
(==) NVIDIA(0): Video key set to default value of 0x83e
(--) NVIDIA(0): Linear framebuffer at 0xEC000000
(--) NVIDIA(0): MMIO registers at 0xE9000000
(--) NVIDIA(0): Found 2 CRTCs on board
(II) NVIDIA(0): Supported display device(s): CRT-0, DFP-0, TV-0
(II) NVIDIA(0): Boot display device(s): DFP-0
(II) NVIDIA(0): NVIDIA GPU detected as: GeForce4 420 Go 32M
(II) NVIDIA(0): Chip Architecture: 0x10
(II) NVIDIA(0): Chip Implementation: 0x17
(II) NVIDIA(0): Chip Revision: 0xa5
(--) NVIDIA(0): VideoBIOS: 04.17.00.61.18
(--) NVIDIA(0): VideoRAM: 32768 kBytes
(II) NVIDIA(0): Connected display device(s): DFP-0
(--) NVIDIA(0): Detected TV Encoder: NVIDIA
(II) NVIDIA(0): Enabled display device(s): DFP-0
(II) NVIDIA(0): Mapping display device 0 (DFP-0) to CRTC 1
(--) NVIDIA(0): Display device DFP-0: maximum pixel clock at 8 bpp: 350 MHz
(--) NVIDIA(0): Display device DFP-0: maximum pixel clock at 16 bpp: 350 MHz
(--) NVIDIA(0): Display device DFP-0: maximum pixel clock at 32 bpp: 350 MHz
(II) Loading sub module "ddc"
(II) LoadModule: "ddc"
(II) Loading /usr/X11R6/lib/modules/libddc.a
(II) Module ddc: vendor="The XFree86 Project"
compiled for 4.3.0, module version = 1.0.0
ABI class: XFree86 Video Driver, version 0.6
(II) NVIDIA(0): --- EDID Information for display device DFP-0 ---
(II) NVIDIA(0): Manufacturer: NVD Model: 100 Serial#: 0
(II) NVIDIA(0): Year: 2002 Week: 45
(II) NVIDIA(0): EDID Version: 1.3
(II) NVIDIA(0): Digital Display Input
(II) NVIDIA(0): Max H-Image Size [cm]: horiz.: 29 vert.: 22
(II) NVIDIA(0): Gamma: 1.00
(II) NVIDIA(0): DPMS capabilities: StandBy Suspend Off; RGB/Color Display
(II) NVIDIA(0): First detailed timing is preferred mode
(II) NVIDIA(0): redX: 0.600 redY: 0.342 greenX: 0.295 greenY: 0.570
(II) NVIDIA(0): blueX: 0.147 blueY: 0.111 whiteX: 0.312 whiteY: 0.328
(II) NVIDIA(0): Manufacturer's mask: 0
(II) NVIDIA(0): Supported additional Video Mode:
(II) NVIDIA(0): clock: 80.0 MHz Image Size: 286 x 215 mm
(II) NVIDIA(0): h_active: 1280 h_sync: 1328 h_sync_end 1440 h_blank_end 1688 h_border: 0
(II) NVIDIA(0): v_active: 854 v_sync: 855 v_sync_end 858 v_blanking: 866 v_border: 0
(II) NVIDIA(0): Monitor name: Nvidia Defaul
(II) NVIDIA(0): Monitor name: t Flat Panel
(II) NVIDIA(0): Ranges: V min: 0 V max: 60 Hz, H min: 29 H max: 48 kHz, PixClock max 90 MHz
(II) NVIDIA(0): --- End of EDID Information for display device DFP-0 ---
(II) NVIDIA(0): EDID reported maximum dimensions for display device DFP-0:
(II) NVIDIA(0): width : 1280
(II) NVIDIA(0): height : 854
(II) NVIDIA(0): Processing requested modes for display device DFP-0:
(II) NVIDIA(0): "1024x768"
(II) NVIDIA(0): "1280x854"
(II) NVIDIA(0): "800x600"
(II) NVIDIA(0): "640x480"
(II) NVIDIA(0): Monitor0: Using hsync range of 29.00-48.00 kHz
(II) NVIDIA(0): Monitor0: Using vrefresh range of 0.00-60.00 Hz
(II) NVIDIA(0): Clock range: 12.00 to 350.00 MHz
(II) NVIDIA(0): Not using mode "1280x854" (hsync out of range)
[...]
(**) NVIDIA(0): Validated modes for display device DFP-0:
(**) NVIDIA(0): Default mode "1024x768": 65.0 MHz, 48.4 kHz, 60.0 Hz
(**) NVIDIA(0): Default mode "800x600": 40.0 MHz, 37.9 kHz, 60.3 Hz
(**) NVIDIA(0): Default mode "640x480": 25.2 MHz, 31.5 kHz, 60.0 Hz
(**) NVIDIA(0): Default mode "800x600": 36.0 MHz, 35.2 kHz, 56.2 Hz
(**) NVIDIA(0): Default mode "512x384": 32.5 MHz, 48.4 kHz, 60.0 Hz (D)
(**) NVIDIA(0): Default mode "400x300": 20.0 MHz, 37.9 kHz, 60.3 Hz (D)
(**) NVIDIA(0): Default mode "400x300": 18.0 MHz, 35.2 kHz, 56.3 Hz (D)
(**) NVIDIA(0): Default mode "320x240": 12.6 MHz, 31.5 kHz, 60.1 Hz (D)
(II) NVIDIA(0): Virtual screen size determined to be 1024 x 768
(--) NVIDIA(0): Display dimensions: (290, 220) mm
(--) NVIDIA(0): DPI set to (89, 88)
-- Matthew.R.Wette at jpl.nasa.gov -- I speak for myself, not for JPL.
- Next message: Bogdan: "Linux on Panasonic CF-73"
- Previous message: Steve Roy: "Re: Open source mail server on windows, oh my..."
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
