Highpoint 1820a driver problem

From: Ken K (kkauffman_at_nospam.headfog.com)
Date: 08/27/04


Date: Fri, 27 Aug 2004 17:36:30 -0400

I'm using the 1820a Highpoint SATA Raid controller on linux (HPT601)
with the OpenBuild driver on Gentoo Hardened SELinux (2.6). After
compiling and loading the driver, I get the following error FOR ALL 8
channels (0-7) which prevents the card from loading:

Far Loopback Diagnostics Failure

The code that handles this is in libmv.c
I simply commented out this piece diagnostic code and rebuild the module
which allows the controller to load and run.

After calling Highpoint support directly, it turns out that it's a
function that the HARD DRIVE does not implement. I'm using (qty) 8 x
160 Gb NCQ Seagate SATA drives. They confirmed that commenting out the
code and rebuilding was the proper avenue to take and would not impact
operation of the card. They also confirmed that this is not a bug in
the card, but in the driver and needed to release a new code version.

This error is independent of RAID configuration (i.e. 1+0, 1, 0, 5, JBOD).

Also note that this bug exists in the Fedora Core supported drivers.
The card will attempt to load if you are installing Fedora Core using
the linux dd (device disk) option. However, it will hang the installer
once it fails to initialize.

Please note that this chipset is not in the linux kernel. I'm posting
this to the USENET as I found ZERO information regarding "far loopback"
or the HPT601 chipset through the search engines. I hope this helps
someone else out there. I also hope that someone with more experience
takes the Highpoint code and tweaks/integrates it into the 2.6 kernel as
it is only available as a module.

ken k



Relevant Pages

  • GeForce 8800 GTS under Linux
    ... But since I do everything else under Linux, ... The card requires a 6-pin PCI-E power connector in order to work. ... Linux X.org - nv driver: ... In order to get support for the 8800GTS from the nv driver, ...
    (comp.os.linux.hardware)
  • Re: How to convert linux ethernet driver to wince driver
    ... I am reading the linux source code now.But I have no knowledge of this card. ... information about how to write driver for this card. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: FA511/tulip cardbus card fails (no EEPROM) on reboot from WinXP
    ... my Netgear FA511 card fails under Linux after rebooting from ... 004C696E7579 (Linux in hex) Tulip driver can't find EEPROM ...
    (comp.os.linux.networking)
  • Re: If Linux is so good----------->>>>>>>>>>>>>>>
    ... Except for the LeadTek thingie (is that a video card? ... properly with linux, I must remove all but the built-in card otherwise I ... I suspect the BIOS is the cause of the problem. ... > since nobody who can write a driver has one of those cards to ...
    (alt.os.linux.suse)
  • Re: If Linux is so good----------->>>>>>>>>>>>>>>
    ... Except for the LeadTek thingie (is that a video card? ... properly with linux, I must remove all but the built-in card otherwise I ... I suspect the BIOS is the cause of the problem. ... > since nobody who can write a driver has one of those cards to ...
    (alt.os.linux)