Re: Set Resolution on X for 19 inch monitor



pkilambi@xxxxxxxxx wrote:

and Also I have not completly switched my screens. I see the same
display both on my lap top and my 19 inch screen.I just connected it
through the monitor cable . The resolution on my laptop screen is small
and neat but the same screen on my 19 in c looks bit bigger..what else
do I nd to do to get smaller and neater picture resolution.

Then the best you can get (see) is max resolution of the laptop the LCD
screen.


Also what are the recommended resolutions for a 19 inch LCD display?

Check the manual for the 19 inch display or use google to find the specs.


I have made the chnages you suggested but nothing seems to change.

All I did was:

- Modified /etc/X11/xorg.conf

- as root an setup --> went to X configuration and it poped up the
display settings screen.

Do you mean system-config-display ran???

But in this the mode does'nt seem to pick the new resolution. and I end
up with the same resolution.. :(

Of course, turn off the laptop LCD screen and restart X, most laptops have a
keystroke combo (Fn+F6 on mine) which can set/switch which display or if
both are active. The default is only the laptop LCD screen is active then
each time I press the keystroke combo what happens is;

First time is both the laptop LCD screen is active and the external monitor
Second time only the external monitor is active
Third time back to the laptop LCD screen as active


--
"A personal computer is called a personal computer because it's yours,
Anything that runs on that computer, you should have control over."
Andrew Moss, Microsoft's senior director of technical policy, 2005
.



Relevant Pages

  • Re: Blank screen after installing Graphics Drivers
    ... Sytem boots into safe mode okay with display and also vga mode okay with ... Remove the drivers and the system will boot normally into windows ... I have tried both DVI and VGA cable to rule out resolution and refresh ... monitor can't use. ...
    (microsoft.public.windows.vista.hardware_devices)
  • Re: Blank screen after installing Graphics Drivers
    ... Sytem boots into safe mode okay with display and also vga mode okay with ... Remove the drivers and the system will boot normally into windows ... I have tried both DVI and VGA cable to rule out resolution and refresh ... monitor can't use. ...
    (microsoft.public.windows.vista.hardware_devices)
  • Screen resolution wont stick after a reboot
    ... I've got two debian systems sharing the same monitor through a Belkin ... (which are the settings that hold the monitor's screen resolution OK): ... SubSection "Display" ...
    (Debian-User)
  • Re: Hooking up tv to computer
    ... connect to the TV and whether it is a standard resolution TV or otherwise. ... My 32" Sony standard TV sucks as a monitor even when set at 1024x768 ... to the TV using S-Video and configure MC settings accordingly, ... display resolution for the TV to 1024x768 in Windows Display properties and ...
    (microsoft.public.windows.mediacenter)
  • Re: screen resolution
    ... Check the spec on the monitor, I would guess that 1440 x 900 is out of ... After installing display ... usually best to keep the resolution at the native resolution of the ... Screen res determines how many pixels of information are displayed ...
    (microsoft.public.windows.mediacenter)