Re: Grub won't boot to linux partion
From: Jesse Benton (jessebent_at_netscape.net)
Date: 04/23/04
- Next message: Boris Glawe: "Re: NTFS for RH9"
- Previous message: Joseph Wong: "Re: Squid Authentication"
- In reply to: Lenard: "Re: Grub won't boot to linux partion"
- Next in thread: Lenard: "Re: Grub won't boot to linux partion"
- Reply: Lenard: "Re: Grub won't boot to linux partion"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Fri, 23 Apr 2004 01:51:58 -0400
Pip and Lenard,
I tried both of your suggestions, and it still fails to see my
partition. I get to the splash screen and select Ferdora. Then it reads
root (0,4) partition does not exist error code 22 hit any key to
continue. I've even tried hdc2, which is what the boot disk says it is
booting to and I get the same results. root(0,4) worked for before this.
Now I'm lost.
Lenard wrote:
> On Thu, 22 Apr 2004 01:56:25 -0400, Jesse Benton wrote:
>
>
>>I recently installed Ferdora, this was an upgrade from RH 7.3. Grub
>>worked fine in RH 7.3 but no longer see my Linux partion in Fedora. This
>>is the way my /ect grub.conf reads. It worked before what am I missing?
>>This system works and boot fine off a floppy. Thanks
>>
>>
>
> <snip>
>
>>> kernel /boot/vmlinuz-2.4.22-1.2115.nptl ro root=LABEL=/ hdd=ide-scsi
>>> initrd /boot/initrd-2.4.22-1.2115.nptl.img
>
>
> Use the drive/partition instead of the partition label, replace
> 'root=LABEL=/' with 'root=/dev/hda5' and you should not need the '/boot'
> portion in either of the two lines.
>
>
>>> kernel /vmlinuz-2.4.22-1.2115.nptl ro root=/dev/hda5 hdd=ide-scsi
>>> initrd /initrd-2.4.22-1.2115.nptl.img
>
>
>
- Next message: Boris Glawe: "Re: NTFS for RH9"
- Previous message: Joseph Wong: "Re: Squid Authentication"
- In reply to: Lenard: "Re: Grub won't boot to linux partion"
- Next in thread: Lenard: "Re: Grub won't boot to linux partion"
- Reply: Lenard: "Re: Grub won't boot to linux partion"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|