Cannot boot into Red Hat Linux 7.3

From: Tabootest (tabootest_at_hotmail.com)
Date: 09/07/04


Date: Tue, 7 Sep 2004 16:00:39 +0800

Dear all,

Our linux server running RH7.3 may have been compromised. When I restart the
server, it hangs at the Loopback. Then I started in a single mode, it gives
the following comments.
1. /etc/rc.sysinit: /bin/awk Text file is busy

2. when I do the ls command, it gives Segmentation fault.

3. when I run the ifconfig -a command, I notice that the network card is in
promiscuous broadcast mode. The network card have no inet address such as
192.168.2.10 which I have set for this card. Also the loopback address
127.0.0.1 doesn't appear.

 What should i do? I suspect it was hacked by someone, or would you suggest
any scanning program for me?

Thanks, thanks.

Regards,

Tabootest



Relevant Pages

  • Cannot boot into Red Hat Linux 7.3
    ... Our linux server running RH7.3 may have been compromised. ... it hangs at the Loopback. ... Then I started in a single mode, ... The network card have no inet address such as ...
    (linux.redhat.install)
  • Cannot boot into Red Hat Linux 7.3
    ... Our linux server running RH7.3 may have been compromised. ... it hangs at the Loopback. ... Then I started in a single mode, ... The network card have no inet address such as ...
    (alt.linux)
  • Cannot boot into Red Hat Linux 7.3
    ... Our linux server running RH7.3 may have been compromised. ... it hangs at the Loopback. ... Then I started in a single mode, ... The network card have no inet address such as ...
    (linux.redhat)
  • Re: Cannot boot into Red Hat Linux 7.3
    ... > Our linux server running RH7.3 may have been compromised. ... it hangs at the Loopback. ... The network card have no inet address such ... Back up all irreplaceable data, reinstall Linux, build a suitable firewall ...
    (linux.redhat.install)
  • Re: Cannot boot into Red Hat Linux 7.3
    ... > Our linux server running RH7.3 may have been compromised. ... it hangs at the Loopback. ... You can make an simple test with rpm to see if there are any changed files or ... do a: rpm -Va ...
    (alt.linux)