how do i enable dhcpcd to stasrt on bootup
tom23499_at_yahoo.com
Date: 08/04/05
- Next message: Lenard: "Re: how do i enable dhcpcd to stasrt on bootup"
- Previous message: Lenard: "Re: Mount windows network partition on startup ?"
- Next in thread: Lenard: "Re: how do i enable dhcpcd to stasrt on bootup"
- Reply: Lenard: "Re: how do i enable dhcpcd to stasrt on bootup"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 3 Aug 2005 18:21:45 -0700
hello eveyone
i'm running mandrake 6.1 (just for learning) went thru the install
(barebone) no frills (no gui) it picked up the dlink DEC nic card
installed the appropriate modules.
ifconfig eth0 shows the nic but with no ip. have to run dhcpcd at the
command line then iconfig eth0 to see the dhcp assigned ip.
during the installation i chose not to enable any of the startup
services like the following :
anacron
apmd
crond
gpm
keytable
linuxconf
netfs
network ********
pcmcia
sendmail
syslog
i've checked the following configuration files:
/etc/sysconfig/network
/etc/sysconfig/network-scripts/ifup and ifdown
/etc/rc.d/init.d/network
can't find how to enable dhcpcd at startup. is it set somewhere in the
compiling of the kernel ? many thanks for the help
- Next message: Lenard: "Re: how do i enable dhcpcd to stasrt on bootup"
- Previous message: Lenard: "Re: Mount windows network partition on startup ?"
- Next in thread: Lenard: "Re: how do i enable dhcpcd to stasrt on bootup"
- Reply: Lenard: "Re: how do i enable dhcpcd to stasrt on bootup"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
