Re: Video Card

From: Robert M. Riches Jr (spamtrap42_at_verizon.net)
Date: 10/25/03


Date: Sat, 25 Oct 2003 04:47:27 GMT

In article <Wmlmb.894$Px2.283@newsread4.news.pas.earthlink.net>,
 Sherman H. wrote:
> Did anyone have trouble in installing Redhat 9.0 with an AGP 8X 128MB Video
> Card? I have been trying to install one but the monitor went off after the
> message showed running Anaconda. . .
>
> Any way to get it to work?

This is a multipost. A counterquestion and an admonition
about multiposting have been posted to other newsgroups, so
the OP can go searching for them.

Robert Riches
spamtrap42@verizon.net
(Yes, that is one of my email addresses.)



Relevant Pages

  • Re: redhat vs debian
    ... I think maybe in terms of video games Linux is week, ... I have UT 2003 and did successfully install it on my RH linux box. ... Finally I switched back the original video card and rebooted. ... monitor and the gforce card. ...
    (linux.redhat)
  • Re: [opensuse] OpenSuse10.3 will not boot into KDM with ATi graphics card
    ... make changes for your frame buffer to work with your monitor. ... In any case, based on your post, I did a clean re-install of 10.3 and made sure to set the res to 1024x768 at the end of the installer config setup. ... So at this point thinking there is something in my hardware that 10.3 didn't like, I went out and bought a cheap nvidia geforce2 mx 400 agp card. ... Did a new clean install to make sure that it was picked up right, and after all that I still did not get x, only the command line showing runlevel 5. ...
    (SuSE)
  • Re: Installing Red Hat with TRUE ASCII text
    ... ]and amber Hercules monitor, and I've been running into some huge ... ]and card to the system for install. ... Install went flawlessly. ... I put the CGA card back in and rebooted. ...
    (comp.os.linux.setup)
  • Re: Ultra10 Creator 13w3 cards issues
    ... I recently struggled with getting my Ultra 10 to work with a Creator3D, ... > I then connected a 13w3-db9 adaptor and hooked it to the same monitor ... UPA card and the U10 only has one UPA slot. ... Then you need to install the drivers for the Creator3D (you say you've ...
    (comp.sys.sun.hardware)
  • Re: Monitor cant be found
    ... GeForce card. ... Now install your new video card and connect the monitor and reboot.XP will ... load its "generic" drivers. ...
    (microsoft.public.windowsxp.hardware)